2006 INFINITI M35 Factory Service Manual

wiring diagramtailgateengine coolantstop startremote startoil
Popular search:
drain boltlumbar supportOBD portECM RESETcruise controlp0340snow chains
Previous
Next
Load previous 8 pages

Page 433 of 5621

INFINITI M35 2006 Factory Service Manual AT-354 ASSEMBLY Revision: 2006 January2006 M35/M45 35. Install needle bearing (rear side) to mid carrier assembly. CAUTION: Take care with the direction of needle bearing. Refer to AT- 2 9 5 , "

Page 434 of 5621

INFINITI M35 2006 Factory Service Manual ASSEMBLY AT-355 D E F G H I J K L MA B AT Revision: 2006 January2006 M35/M45 40. Install band servo anchor end pin and lock nut in transmission case. CAUTION: Do not reuse band servo anchor

Page 435 of 5621

INFINITI M35 2006 Factory Service Manual AT-356 ASSEMBLY Revision: 2006 January2006 M35/M45 45. Adjust brake band. a. Loosen lock nut. b. Tighten band servo anchor end pin to specified torque. c. Back of band servo anchor end pin three turns

Page 436 of 5621

INFINITI M35 2006 Factory Service Manual ASSEMBLY AT-357 D E F G H I J K L MA B AT Revision: 2006 January2006 M35/M45 b. Measure dimension “L”. c. Calculate dimension “J”. 2. Measure dimensions “M 1 ” and “M2 ” and then calcu

Page 437 of 5621

INFINITI M35 2006 Factory Service Manual AT-358 ASSEMBLY Revision: 2006 January2006 M35/M45 d. Calculate dimension “M”. 3. Adjust total end play “T 1 ”. Select proper thickness of bearing race so that total end play is within specifi

Page 438 of 5621

INFINITI M35 2006 Factory Service Manual ASSEMBLY AT-359 D E F G H I J K L MA B AT Revision: 2006 January2006 M35/M45 3. Install oil pump assembly in transmission case. CAUTION: Apply ATF to oil pump baring. 4. Apply recommended sealant (

Page 439 of 5621

INFINITI M35 2006 Factory Service Manual AT-360 ASSEMBLY Revision: 2006 January2006 M35/M45 8. Make sure that brake band does not close turbine revolution sensor hole. 9. Install control valve with TCM. a. Connect TCM connector a

Page 440 of 5621

INFINITI M35 2006 Factory Service Manual ASSEMBLY AT-361 D E F G H I J K L MA B AT Revision: 2006 January2006 M35/M45 d. Install O-ring to A/T assembly harness connector. CAUTION: Do not reuse O-ring. Apply ATF to O-ring. e. Install A/T flui
Load next 8 pages
Page:   < prev 1-10 ... 401-408 409-416 417-424 425-432 433-440 441-448 449-456 457-464 465-472 ... 5624 next >
tow barturn signalbrakesoildead batterytowing capacity
Popular search:
fog lightphonesnow chainsgroundcheck engineturn signalcatalytic converter