Page 89 of 3039
7 
 Sanding Paper 8 
 Drill through the shown number of body panel layers with a specified diameter 9 
 Drill through the shown number of body panel layers with a suitable diameter 10 
 Drill through 1 body panel layer with a specified diameter 11 
 Drill through 1 body panel layer with a suitable diameter 12 
 Wire brush  
         
        
        
     
        
        Page 90 of 3039
1 
 Apply a bead from the specified tube 2 
 Apply a bead from the specified cartridge 3 
 Apply the specified chemical with a brush 4 
 Apply the specified load to the specified component 5 
 Apply a bead with a specific diameter from the specified tube www.JagDocs.com 
         
        
        
     
        
        Page 91 of 3039
7 
 Apply the specified chemical with a roller 8 
 Apply hot glue to the specified component 9 
 Apply the specified amount of fluid from the fluid can 10 
 Apply fluid from the fluid can 11 
 Clean the specified component with the specified material 12 
 Apply a broken bead from the specified tube 13 
 Apply the specified chemical from a spray can 14 
 Apply the specified lubricant to the specified component 15 
 Apply spot welds to the specified component 16 
 Apply a continuous weld to the specified component 17 
 Handle the fluid using a syringe 18 
 Extract the specified amount of fluid using a syringe  
         
        
        
     
        
        Page 92 of 3039
1 
 Measure the current using a digital multimeter 2 
 Measure the voltage using a digital multimeter 3 
 Measure the resistance using a digital multimeter 4 
 Measure the length/distance 5 
 Check that the specified pressure is available using a suitable pressure gauge  
         
        
        
     
        
        Page 93 of 3039
7 
 Measure the time using a suitable stopwatch 8 
 Wait for the specified period of time 9 
 The specified task requires the specified minimum temperature 10 
 The specified task requires the specified maximum temperature not to be exceeded 11 
 The specified task requires the specified temperature range 12 
 The specified task requires the specified temperature 13 
 Measure and check for the specified value using a dial indicator gauge 14 
 Measure and check for the specified MAX value using a dial indicator gauge 15 
 Measure and check for the specified MIN value using a dial indicator gauge  
         
        
        
     
        
        Page 94 of 3039
1 
 Hot air gun 2 
 Soldering iron 3 
 Scraper 4 
 Scriber 5 
 Securing strap  
         
        
        
     
        
        Page 95 of 3039
7 
 Center punch 8 
 Marker 9 
 Metal inert gas (MIG) welding equipment 10 
 Hose clamp 11 
 Interior trim remover 12 
 Vacuum cleaner 13 
 Strap wrench 14 
 Wedge 15 
 Pin Punch Material symbols 
 
The material symbols are used to show where to use which type of material to carry out a procedure step. 
 
 
 
Item 
 Description 1 
 Remove/Install the specified blind rivet 2 
 Apply tape to the specified component/area 3 
 Remove/Install the specified cable tie www.JagDocs.com 
         
        
        
     
        
        Page 96 of 3039
1 
 Set the ignition switch to the 0 position 2 
 Set the ignition switch to the II position 3 
 The procedure step requires the aid of the specified number of supporting technicians 4 
 Self contained breathing apparatus 5 
 General prohibition used in combination with another symbol