Page 569 of 3039
Remove and discard the circlip.
1. Clean the components mating faces.
Page 570 of 3039
3. CAUTION: Use Loctite WSK-M2G349-A4 or equivalent,
meeting the Jaguar specification.
Install a new circlip.
4. CAUTION: The halfshaft oil seal protector must be left
in place, until the halfshaft is fully installed.
Install the halfshaft oil seal protector. www.JagDocs.com
Page 571 of 3039
5. CAUTIONS:
Do not install the rear halfshaft fully at this stage.
Only install the rear halfshaft until the halfshaft
splines have past the halfshaft oil seal.
6. Remove and discard the halfshaft oil seal plutector.
7. CAUTION: Make sure that the rear halfshaft circlip is
installed correctly by pulling the halfshaft gently to make
sure it is engaged.
8. CAUTION: The final tightening of the suspension
components must be carried out with the vehicle on its
wheels.
Torque: 90 Nm
Page 572 of 3039
9.
10.
11. CAUTION: Install the halfshaft nut finger tight.
NOTE: Do not fully tighten the locking nut at this
stage.
CAUTION: The final tightening of the suspension
components must be carried out with the vehicle on its
wheels.
Torque: 150 Nm
CAUTION: The final tightening of the suspension
components must be carried out with the vehicle on its
wheels.
Torque: 55 Nm
Page 573 of 3039
Install the brake disc.
Torque: 103 Nm
Page 574 of 3039
15.
16. CAUTION: Do not use air tools to install the nut.
Failure to follow this instruction may result in damage to
the component.
Torque: 300 Nm
Check and top-up the differential case.
17.
Install the LH rear wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
Page 575 of 3039
Rear Drive Halfshafts - Inner Constant Velocity (CV) Joint Boot
Removal and Installation
Removal Published: 11-May-2011
1. WARNING: Do not work on or under a vehicle supported only by a
jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the rear halfshaft.
For additional information, refer to: Rear Halfshaft - TDV6 3.0L Diesel /V8 5.0L Petrol/V8 S/C 5.0L Petrol (205-05 Rear Drive Halfshafts, Removal and Installation).
3. CAUTION: Use suitable protective covers to protect the halfshaft.
Using a suitable clamp, secure the rear halfshaft.
4. CAUTION: Make sure the inner constant velocity (CV)
joint is not separated from the halfshaft.
Remove and discard the inner CV joint boot retaining clip.
5. CAUTION: Make sure the CV joint ball bearings do not
drop out of the CV joint.
Using a suitable tool, remove the inner CV joint. www.JagDocs.com
Page 576 of 3039
6. Remove the inner CV joint boot.
Remove and discard the retaining clip.
Installation
1. NOTE: Make sure that the protective sleeve is
correctly installed, prior to installing the CV joint boot.
2. NOTE: Install a new retaining clip.