Page 505 of 3039
Vehicles with diesel engine
7.
8.
All vehicles
9.
Remove the support bracket.
Remove the bolts.
Detach the intermediate muffler exhaust hanger
insulators.
Loosen the catalytic converter to diesel particulate filter
(DPF) retaining clamps.
CAUTION: Make sure that the exhaust system is
supported with a suitable transmission stand.
Lower the exhaust assembly sufficiently to gain access to
the driveshaft heat shield.
Release the 6 exhaust hangers.
Page 506 of 3039
10. Remove the driveshaft heat shield.
All vehicles
11.
CAUTION: Make sure that the special tool is correctly
located.
Using the special tool, align the driveshaft center bearing.
Tighten to 40 Nm.
Page 507 of 3039
12.
13. Install the driveshaft heat shield.
Tighten to 10 Nm.
CAUTION: Make sure that the exhaust system is
supported with a suitable transmission stand.
Attach the exhaust hangers.
Page 508 of 3039
Vehicles with diesel engine
14.
15. Tighten the catalytic converter to DPF retaining clamps.
Tighten to 11 Nm.
Install the support bracket.
Attach the intermediate muffler exhaust hanger
insulators.
Tighten to 10 Nm.
All except vehicles with diesel engine
16. Tighten the retaining nuts.
Tighten to 45 Nm.
Page 509 of 3039
17. Install the support bracket.
Tighten to 10 Nm.
All vehicles
18. Install the rear subframe cross brace.
Tighten to 62 Nm. www.JagDocs.com
Page 510 of 3039
Panels, Removal and Installation).
Page 511 of 3039
Centre bearing retaining bolts 48 36 - Transmission flexible joint retaining bolts 127 94 - Rear drive axle CV joint retaining bolts 73 54 - Driveshaft heat shield retaining bolts 7 - 62
Page 512 of 3039
1 Transmission flexible joint 2 Collapsible front driveshaft tube 3 Splined slip joint 4 Center bearing 5 Universal joint 6 Rear driveshaft tube 7 Differential flexible joint