Page 353 of 3039
Suspension, Removal and Installation). www.JagDocs.com
Page 354 of 3039
Front Suspension - Shock Absorber Bushing
Removal and Installation
Special Tool(s)
Replacer support-bush
204-337
Replacer-bush
204-338
Remover-bush
204-336
Remover support-bush
204-335
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Published: 11-May-2011
1. WARNING: Do not work on or under a vehicle supported only by a jack.
Always support the vehicle on safety stands.
Raise the vehicle on a 4 post lift.
2. Remove the rear lower arm.
For additional information, refer to: Rear Lower Arm (204-01 Front Suspension, Removal and Installation).
Page 355 of 3039
3. NOTE: Take note of the fitted position of the bush. Using
the special tools, remove the shock absorber bushing.
Installation
1. NOTE: Make sure the shock absorber bushing boot is
correctly located into the special tool.
Install the bushing into the special tool.
2. NOTE: Align to the position noted on removal.
Using the special tools, install the shock absorber bushing.
3. Install the rear lower arm.
For additional information, refer to: Rear Lower Arm (204-01 Front Suspension, Removal and Installation).
Page 356 of 3039

Published: 06-Jun-2013
Front Suspension - Front Stabilizer Bar V8 5.0L Petrol/V8 S/C 5.0L Petrol
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
2. WARNING: Do not work on or under a vehicle supported only by a jack.
Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging (412-00 Climate Control System - General Information, General Procedures).
4. Refer to: Radiator Splash Shield (501-02 Front End Body Panels, Removal and Installation).
5. Refer to: Air Deflector (501-02 Front End Body Panels, Removal and Installation).
6. Refer to: Front Wheel Bearing and Wheel Hub - TDV6 3.0L Diesel /V8 5.0L Petrol/V8 S/C 5.0L Petrol (204-01 Front Suspension, Removal and Installation).
7. Refer to: Engine Cover - V8 5.0L Petrol/V8 S/C 5.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
8.
Secure the radiator assembly. 303-021
Engine support bracket Special Tool(s) www.JagDocs.com
Page 357 of 3039
Page 358 of 3039
11.
12.
13.
14. NOTE: LH illustration shown, RH is similar.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 45 Nm
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 100 Nm
Page 359 of 3039
Page 360 of 3039
18.
19.
20.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 5 Nm
21.
Lower the vehicle.