Page 2769 of 3039
(100-00 General Information, Description and Operation) /
Body Repairs (501-25A Body Repairs - General Information, Description and Operation) /
Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) /
Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
4. Remove the hood latch panel.
For additional information, refer to: Hood Latch Panel (501-27 Front End Sheet Metal Repairs, Removal and Installation).
5. Remove the front fender.
For additional information, refer to: Front Fender (501-27 Front End Sheet Metal Repairs, Removal and Installation).
6. Disconnect the generator electrical connectors.
7. If the left-hand fender apron panel front extension is to be repaired, www.JagDocs.com
Page 2770 of 3039
Page 2771 of 3039
Page 2772 of 3039

Published: 11-May-2011
Front End Sheet Metal Repairs - Fender Apron Panel Front Section
Removal and Installation
Removal
1. NOTE: The fender apron panel front section is
manufactured from mild steel.
The fender apron panel front section is cut from the fender
apron service panel.
2. The fender apron panel front section is replaced in conjunction with:
Front bumper cover
Hood
Front fender
Hood latch panel
Fender apron panel front extension
Fender apron closing panel front section
3. For additional information relating to this repair procedure please see
the following:
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) /
Body Repairs (501-25A Body Repairs - General Information, Description and Operation) /
Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) /
Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
4. NOTE: Make sure the fender apron closing panel front section is cut to
allow a minimum 50mm staggered joint with the fender apron panel
front section.
Remove the fender apron closing panel front section.
For additional information, refer to: Fender Apron Closing Panel Front Section (501-27 Front End Sheet Metal Repairs, Removal and Installation).
5. Disconnect the generator electrical connectors.
Page 2773 of 3039
Page 2774 of 3039
Page 2775 of 3039
Page 2776 of 3039

Front End Sheet Metal Repairs - Front Bumper Mounting
Removal and Installation
Removal Published: 11-May-2011
1. NOTE: The front bumper mounting is manufactured from
High Strength Low Alloy steel, 350MPa, (HSLA350).
The front bumper mounting is serviced as a separate
weld-on panel, it is also serviced on the front side member
& suspension top mount assembly.
2. The front bumper mounting is replaced in conjunction with:
Front bumper cover
Front bumper
Hood latch panel
3. For additional information relating to this repair procedure please see
the following:
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation) /
Body Repairs (501-25A Body Repairs - General Information, Description and Operation) /
Corrosion Protection (501-25B Body Repairs - Corrosion Protection, Description and Operation) /
Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
4. Remove the hood latch panel.
For additional information, refer to: Hood Latch Panel (501-27 Front End Sheet Metal Repairs, Removal and Installation).
5. Disconnect the generator electrical connectors.
6. Drill out the spot welds.
7. Separate the joints and remove the old panel.