1998 ISUZU TROOPER Service Repair Manual

Page 1425 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±308
ENGINE DRIVEABILITY AND EMISSIONS
Accelerator Pedal Replacement
Removal Procedure
1. Disconnect the cruise control cable from the
accelerator pedal assembly.
TS24053
2. Disconnect the accelera

Page 1426 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±309 ENGINE DRIVEABILITY AND EMISSIONS
Installation Procedure
1. Install the accelerator pedal assembly on the
bulkhead.
2. Install the two screws to the accelerator pedal
assembly.
TS24055
3. Conn

Page 1427 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±310
ENGINE DRIVEABILITY AND EMISSIONS
Pedal Stroke Adjustment Procedure
1. Loosen the jam nut and rotate the kick-down switch
counterclockwise.
TS24039
2. Fully depress the pedal and hold it by ha

Page 1428 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±311 ENGINE DRIVEABILITY AND EMISSIONS
3. Disconnect the fuel line from the fuel filter on the
engine side.
4. Disconnect the fuel line from the fuel filter on the fuel
tank side.
041RW006
5. Remov

Page 1429 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±312
ENGINE DRIVEABILITY AND EMISSIONS
Installation Procedure
1. Install the fuel filter in the correct direction.
041RW008
2. Install the bolt on the fuel filter holder.
041RW007
3. Connect the fu

Page 1430 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±313 ENGINE DRIVEABILITY AND EMISSIONS
Fuel Gauge Unit
Removal Procedure
1. Disconnect the negative battery cable.
2. Loosen the fuel filler cap.
3. Drain the fuel from the tank.
Tighten
Tighten t

Page 1431 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±314
ENGINE DRIVEABILITY AND EMISSIONS
3. Connect the wiring connector to the fuel gauge unit.
TS23771
4. Fill the fuel tank with fuel.
Tighten the fuel filler cap.
Check for leaks at the fuel ga

Page 1432 of 3573

ISUZU TROOPER 1998  Service Repair Manual 6E±315 ENGINE DRIVEABILITY AND EMISSIONS
Installation Procedure
1. Install the O-ring backup on the fuel injector.
2. Install the new O-ring on the fuel injector.
3. Install the fuel injector on the