Page 1425 of 3229
14.
Installation
1. CAUTION: "Make sure t hat a new component isi ns t alled. "1.
To i nst all , revers e t he removal procedure.2.
Bleed t he clut ch sys t em.
Refer t o: Clutch Sys tem Bleeding (308-00 ManualTrans mi ss ion/Transaxle and Clut ch - General Informati on, GeneralProcedures ).
3.
Page 1426 of 3229
Publi s hed: 11-May-2011
Clutch Controls - Clutch PedalLHD AWD
Removal and Inst all ati on
Removal
Di sconnect t he bat t ery ground cable.
Refer t o: Specificati ons (414-00 Bat tery and Charging Sys tem -General Informat ion, Specificati ons).
1.
Remove t he bat t ery t ray.
Refer t o: Bat t ery Tray (414-01 Bat tery, Mount ing and Cables ,Removal and Ins tall ati on).
2.
3. CAUTION: Brake flui d wil l damage pai ntfinis hed s urfaces . If s pil led, immedi ately remove t hefluid and cl ean the area wit h wat er.
• NOTE: Pos it ion clot h t o col lect fl uid s pil lage.
3.
4. NOTE: If equiped4.
Remove t he ins trument panel as sembl y.
Refer t o: Ins trument Panel - TD4 2.2L Dies el (501-12 Inst rumentPanel and Cons ole, Removal and Inst all at ion).
5.
Page 1427 of 3229
Page 1428 of 3229
9. CAUTION: "Make sure t hat a new component isi ns t alled. "
Cut t he head off the cl evi s pin to al low removal.
9.
10.
Installation
1. CAUTION: "Make sure t hat a new component isi ns t alled. "1.
To i nst all , revers e t he removal procedure.2.
Page 1429 of 3229
Bleed t he clut ch sys t em.
Refer t o: Clutch Sys tem Bleeding (308-00 ManualTrans mi ss ion/Transaxle and Clut ch - General Informati on, GeneralProcedures ).
3.
Page 1430 of 3229

Publi s hed: 11-May-2011
Manual Transmission/Transaxle - Transmission Draining and Filling
General Procedures W ARNING: Observe due care when drai ning, as the flui d can be very hot .
1. W ARNING: Do not work on or under a vehi cle s upported onl y
by a jack. Al ways support t he vehi cl e on s afet y s tands .
• NOTE: Make s ure that t he vehi cl e is st andi ng on a level s urface.
Rais e and s upport t he vehi cl e.
1.
Remove t he front unders hiel d.
Refer t o: Engi ne Unders hi eld (501-02 Front End Body Panel s ,
Removal and Ins tall ati on).
2.
Clean t he area around the trans mi s si on fl uid l evel /fil ler plug.
3. Remove the trans mi ss i on fl uid fil ler/level plug.
4.
Clean t he area around the trans mi s si on fl uid drain pl ug.
5.
Place a contai ner under the t rans mi ss i on.
6. Remove the trans mi ss i on fl uid drai n plug.
7.
8. CAUTION: Replace t he washer.
Inst all t he transmis si on fluid drain pl ug.
T orque: 30 Nm 8.
Fil l the t rans mi ss ion wit h t he correct fl uid unt il it runs from t he
l evel/fi ll er pl ug.
9.
Page 1431 of 3229
10. CAUTION: Replace the washer.
Inst all t he transmis si on fluid fil ler/l evel plug.
T orque: 35 Nm 10.
Inst all t he front unders hiel d.
Refer t o: Engi ne Unders hi eld (501-02 Front End Body Panel s ,
Removal and Ins tall ati on).
11.
Page 1432 of 3229

Publi s hed: 11-May-2011
Manual Transmission/Transaxle - Transmission Fluid Level Check
General Procedures W ARNING: Observe due care when drai ning, as the flui d can be very hot .
1. W ARNING: Do not work on or under a vehi cle s upported onl y
by a jack. Al ways support t he vehi cl e on s afet y s tands .
• NOTE: Make s ure that t he vehi cl e is st andi ng on a level s urface.
Rais e and s upport t he vehi cl e.
1.
Remove t he front unders hiel d.
Refer t o: Engi ne Unders hi eld (501-02 Front End Body Panel s ,
Removal and Ins tall ati on).
2.
Clean t he area around the trans mi s si on fl uid l evel /fil ler plug.
3. Remove the trans mi ss i on fl uid fil ler/level plug.
4.
Fil l the t rans mi ss ion wit h t he correct fl uid unt il it runs from t he
l evel/fi ll er pl ug.
5.
6. CAUTION: Replace t he washer.
Inst all t he transmis si on fluid fil ler/l evel plug.
T orque: 35 Nm 6.
Inst all t he front unders hiel d.
Refer t o: Engi ne Unders hi eld (501-02 Front End Body Panel s ,
Removal and Ins tall ati on).
7.