Page 2193 of 3229

Publi s hed: 11-May-2011
Seating - Front Seat Backrest Cover
Removal and Inst all ati on
Removal
• W ARNINGS:
To avoid accidental depl oyment , t he res traint s cont rol module backup power s upply mus t be deplet ed. W ait at leas tone mi nut e after dis connecti ng the bat tery ground cabl e(s ) before commenci ng any repair or adjus tment t o t hes uppl ement al res traint s yst em (SRS), or any component(s ) adjacent t o t he SRS s ens ors. Fail ure t o follow thes eins t ructi ons may res ult i n pers onal i njury.
Al ways wear s afet y glas s es when working on an air bag equipped vehi cl e and when handl ing an ai r bag module.Failure t o fol low this ins truct ion may res ult i n pers onal i njury.
To minimize t he pos s ibi lit y of premat ure depl oyment , do not us e radio key code s avers when working on thes uppl ement al res traint s yst em. Failure t o fol low this ins truct ion may res ult i n personal i njury.
To minimize t he pos s ibi lit y of i njury i n t he event of premat ure depl oyment , al ways carry a li ve air bag module wit ht he bag and trim cover point ed away from t he body. Fail ure t o follow thi s ins t ructi on may res ult i n pers onal injury.
To minimize t he pos s ibi lit y of premat ure depl oyment , live ai r bag modules mus t only be pl aced on work bencheswhich have been ground bonded and wit h t he trim cover facing up. Fail ure t o follow thes e i ns t ructi ons may res ult i npers onal i njury.
Never probe t he elect rical connect ors of air bag modules or any ot her s upplemental res t rai nt s ys tem component.Failure t o fol low this ins truct ion may res ult i n pers onal i njury.
Paint ing over the driver air bag module trim cover or ins trument panel coul d lead to det eriorat ion of t he t ri m coverand air bags. Do not for any reas on att empt to pai nt dis col ored or damaged air bag module trim covers or i nst rumentpanel . Ins tal l a new component . Fai lure to foll ow t his i nst ruct ion may res ul t in pers onal injury.
Make s ure that s ufficient ti me has el aps ed aft er dis connecti ng the bat tery ground cabl e(s ), before commencing workon t he s uppl ement al res traint s ys t em (SRS). Fail ure t o fol low thes e ins t ructi ons may res ult i n pers onal i njury.
• NOTE: Removal s t eps in t his procedure may cont ain i nst all ati on det ail s.
Di sconnect t he bat t ery ground cable.
Refer t o: Specificati ons (414-00 Bat tery and Charging Sys tem -General Informat ion, Specificati ons).
1.
Make t he SRS s ys t em s afe.
Refer t o: Standard W orks hop Pract ices (100-00 General Informat ion,Des cript ion and Operat ion).
2.
Remove t he front safet y belt buckle.
Refer t o: Front Safety Bel t Buckle (501-20A Safet y Belt Sys tem,Removal and Ins tall ati on).
3.
Page 2194 of 3229
Page 2195 of 3229
T orque:
25 Nm 6.
7.
Remove t he s eat armres t .
Refer t o: Front Seat Armres t (501-10 Seat ing, Removal and
Inst all at ion).
8.
Page 2196 of 3229
9.
10.
Installation
To i nst all , revers e t he removal procedure.1.
Page 2197 of 3229
Publi s hed: 11-May-2011
Seating - Front Seat Control Switch
Removal and Inst all ati on
Removal 1.
2.
Installation To i nst all , revers e t he removal procedure.
1.
Page 2198 of 3229
Publi s hed: 11-May-2011
Seating - Rear Seat Backrest Cover
Removal and Inst all ati on
Removal
• NOTE: This procedure covers t he removal and ins t al lat ion of both rear s eat backrests and t he LH rear seat backres tcover. The RH rear s eat backres t cover is si mil ar. Al l not es and caut ions mus t be fol lowed s t ri ct ly to avoid any chance ofNVH or failure of the rear s eat backrest s .
1.
2.
Page 2199 of 3229
Releas e t he RH rear s eat backres t outer pivot pinbus hi ng.3.
Us ing a s crewdriver, releas e t he out er pivot pin bus hingl ocking arm.4.
5. CAUTION: The l eft-hand rear s eat backres ti nner pivot pin has radial grooves . W hen removing t heRH backres t from t he LH backres t take care not t odamage t he RH backrest i nner pi vot bus hing.
Releas e t he RH rear s eat backres t outer pivotpin bus hing from t he mounti ng bracket .Releas e t he RH rear s eat backres t from the LHrear s eat backres t .
5.
Page 2200 of 3229
Remove and dis card t he RH rear seat backrest out erpivot pin bus hing.6.
If ins tal led, releas e t he armres t.Remove and dis card t he armres t pivot bus hings pri ng cl ips .
7.
Sli de t he armrest upwards .Sli de t he armrest out wards .
8.