Page 897 of 3229
22. CAUTION: Be prepared to col lect es capingfluids .
Di sconnect t he low pres sure li ne from the powers teering pump.
22.
Releas e t he power s t eering hi gh-pres s ure pi pe.23.
24. CAUTIONS:
Di s card the seal.
Make s ure that all openings are sealed.
24.
Page 898 of 3229
25. CAUTIONS:
Di s card the seal.
Make s ure that all openings are sealed.
Di sconnect t he A/C compress or low-pres s ure refrigerantl ine.
25.
Remove t he top hos e.26.
27. CAUTION: Be prepared to col lect es caping fuel .
Di sconnect t he 2 fuel l ines.
27.
Releas e t he 2 fuel l ines.28.
Page 899 of 3229
Di sconnect t he bot t om hos e.29.
Remove t he charge air cool er inlet pipe.30.
Di sconnect t he charge air cool er out let hos e.31.
Page 900 of 3229
Di sconnect t he engi ne wiring harnes s .32.
LH s i de: Releas e 4 engine compartment ground cables .33.
Page 901 of 3229
Remove t he cool ant expans i on tank.34.
Releas e t he dri ves haft from the t rans mi ss i on driveflange.35.
Di sconnect 2 heater hos es from t he bulkhead.36.
Page 902 of 3229
37. CAUTION: If brake fl uid i s s pilt on the
paint work, the affected area mus t be i mmediat el y
was hed down wit h cold wat er.
Di sconnect t he cl utch fluid hos e.
37. Support the engi ne.
General Equi pment: Powert rai n Jack 38.
Remove t he LH engine mount bracket .
39.
Page 903 of 3229
Remove t he LH engine mount.40.
RH si de: Rel eas e t he engine mount .41.
W it h ass i st ance, careful ly remove the engi ne andt rans mis s ion.42.
Page 904 of 3229
Publi s hed: 11-May-2011
Engine - TD4 2.2L Diesel - Engine
Installation
General Equipment Powert rai n Jack W it h ass i st ance, careful ly i nst all t he engi ne and
t rans mis s ion.
General Equi pment: Powert rai n Jack 1.
RH si de: Ins tall t he engine mount .
T orque: 80 Nm 2.
Inst all t he LH engine mount.
T orque: 175 Nm 3.
Inst all t he bracket .
T orque: M12 80 Nm M8
25 Nm 4.
Remove t he engi ne s upport .
5.
Connect t he clutch flui d hose.
6.
Connect t he bulkhead heat er hos es.
7.
8. CAUTIONS: Make s ure that t he component is cl ean, free of foreign
mat eri al and l ubricant.
8.