2003 NISSAN ALMERA N16 Electronic Repair Manual

Page 209 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual Primary Timing ChainNJEM0094
JEM130GA
GI
MA
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
TIMING CHAINYD
Primary Timing Chain
EM-25

Page 210 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual REMOVALNJEM0094S011. Remove engine and transaxle assembly. Refer to EM-63,
“ENGINE ASSEMBLY”.
2. Remove transaxle from engine. Place engine onto engine
stand (SST). Refer to EM-67, “CYLINDER BLO

Page 211 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM134G
9. Remove chain tensioner.
When removing chain tensioner, push the sleeve of chain ten-
sioner and keep it pressed with a push pin, etc.
10. Remove timing chain slack guide.
JEM135G
11. Hold f

Page 212 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM138G
16. Remove rear chain case.
Loosen fixing bolts in the reverse order of that shown in the
figure and remove them.
Use seal cutter (SST) for removal.
INSPECTIONNJEM0094S02Check for cracks and e

Page 213 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM140G
1. Install rear chain case.
a. Apply a continuous bead of specified liquid gasket (Refer to
EM-3, “Liquid Gasket Application Procedure”.) on locations
shown in the figure.
A: Apply bead so

Page 214 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM137G
2. Install power steering pump.
3. Install fuel injection pump.
Before installing, make sure the notch on the fuel injection
pump flange and the hole 6 mm (0.24 in) in diameter on the
pump bod

Page 215 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM143G
12. Install chain case cover (for opening for power steering pump
removal/installation) to oil pump.
Apply a continuous bead of specified liquid gasket (Refer to
EM-3, “Liquid Gasket Applica

Page 216 of 3189

NISSAN ALMERA N16 2003  Electronic Repair Manual JEM147G
15. Install crankshaft pulley.
a. Install crankshaft pulley to crankshaft.
b. Hold crankshaft pulley with the pulley holder (SST).
c. Tighten bolt to 20 to 29 N·m (2.0 to 3.0 kg-m, 15 to 21 f