2003 NISSAN ALMERA N16 Electronic Repair Manual

alternatorlanguagechild lockoil levelgas tank sizedrain bolt
Popular search:
brake rotorstartingrestraintp1251starter relayclock settingcooling fan wiring diagram
Previous
Next
Load previous 8 pages

Page 1241 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual 2) Start engine and run it for at least 2 seconds at idle speed. (If engine does not run, turn ignition switch to “START” for at least 2 seconds.) 3) Turn ignition switch “OFF”, wait at least

Page 1242 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual DescriptionNJEC0760SYSTEM DESCRIPTIONNJEC0760S01 Sensor Input Signal to ECMECM Func- tionActuator Crankshaft position sensor (TDC)Engine speed Glow controlGlow lamp, Glow relay " Glow plugs Engine

Page 1243 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual ECM Terminals and Reference ValueNJEC0761Specification data are reference values and are measured between each terminal and ground. CAUTION: Do not use ECM ground terminals when measuring input/output

Page 1244 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual Wiring DiagramNJEC0762 YEC328A GLOW CONTROL SYSTEMYD Wiring Diagram EC-190

Page 1245 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual Diagnostic ProcedureNJEC0763 1 INSPECTION START Check fuel level, fuel supplying system, starter motor, etc. OK or NG OK GO TO 2. NG Correct. 2 CHECK INSTALLATION Check that glow plug nut and all glow

Page 1246 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual 4 CHECK GLOW INDICATOR LAMP OPERATION Without CONSULT-II 1. Turn ignition switch “ON”. 2. Confirm that the voltage between ECM terminal 347 (Engine coolant temperature sensor signal) and ground is

Page 1247 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual 6 CHECK GLOW INDICATOR LAMP POWER SUPPLY CIRCUIT 1. Turn ignition switch “OFF”. 2. Disconnect combination meter harness connector M171. 3. Turn ignition switch “ON”. 4. Check voltage between c

Page 1248 of 3189

NISSAN ALMERA N16 2003 Electronic Repair Manual 11 CHECK GLOW RELAY POWER SUPPLY CIRCUIT 1. Turn ignition switch “OFF”. 2. Disconnect glow relay. SEF391Y 3. Check voltage between glow relay terminals 1, 5 and ground with CONSULT-II or tester. S
Load next 8 pages
Page:   < prev 1-10 ... 1209-1216 1217-1224 1225-1232 1233-1240 1241-1248 1249-1256 1257-1264 1265-1272 1273-1280 ... 3192 next >
dead batteryinterior lightsrear view mirrortowkey fob batterypower steering
Popular search:
srs troublefuel capfuse diagramDiagnosticremove seatsbrakesnats immu