Page 1641 of 4331
EC
NP
O
• If the fuel filler cap is not tigh
tened properly, the MIL may come on.
• Use only a genuine NISSAN rubber tube as a replacement.
DTC CONFIRMATION PROCEDURE YES >> GO TO 2.
NO >> GO TO 3. BASIC INSPECTION : Special Repair Requirement " .
Which is displayed on CONSULT-III screen? OK >> INSPECTION END
NG >> Go to EC-285, " Diagnosis Procedure " .
How to Set SRT Code " before driving
vehicle.
1. Start engine.
2. Drive vehicle according to DRIVING PATTERN.
3. Stop vehicle.
4. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
5. Select Service $07 with GST.
Is 1st trip DTC displayed? YES-1 >> P0441: Go to
EC-280, " Diagnosis Procedure " .
YES-2 >> P0442: Go to EC-285, " Diagnosis Procedure " .
NO >> INSPECTION END
Diagnosis Procedure INFOID:0000000004780173
Page 1642 of 4331
YES >> GO TO 2.
NO >> Replace with genuine NISSAN fuel filler cap. YES >> GO TO 3.
NO >> Open fuel filler cap, then clean cap and fuel filler neck threads using air blower. Then retighten until ratcheting sound is heard. YES >> GO TO 5.
NO >> GO TO 4. Component Inspection (Fuel filler cap) " .
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace fuel filler cap with a genuine one. Inspection " .
Is there any leak in EVAP line? YES >> Repair or replace.
NO >> GO TO 6. Component Inspection (Drain filter) " .
Is the inspection result normal? YES >> GO TO 7.
NO >> Replace drain filter. Exploded View " .
• EVAP canister vent control valve. Refer to EC-304, " Component Inspection " .
Is the inspection result normal? YES >> GO TO 8.
NO >> Repair or replace EVAP cani ster vent control valve and O-ring.
Page 1643 of 4331
EC
NP
O
2. Does water drain from the EVAP canister?
Does water drain from the EVAP canister?YES >> GO TO 9.
NO-1 >> With CONSULT-III: GO TO 11.
NO-2 >> Without CONSULT-III: GO TO 12. YES-1 >> With CONSULT-III: GO TO 11.
YES-2 >> Without CONSULT-III: GO TO 12.
NO >> GO TO 10. YES >> GO TO 14.
NO >> GO TO 13. YES >> GO TO 14.
NO >> GO TO 13. System Description " .
Is the inspection result normal? Vacuum should exist.
Page 1644 of 4331
Component Inspection " .
Is the inspection result normal? YES >> GO TO 15.
NO >> Replace EVAP canister purge volume control solenoid valve. Component Inspection " .
Is the inspection result normal? YES >> GO TO 16.
NO >> Replace fuel level sensor unit. DTC Logic " .
Is the inspection result normal? YES >> GO TO 17.
NO >> Replace EVAP control system pressure sensor. System Description " .
Is the inspection result normal? YES >> GO TO 18.
NO >> Repair or reconnect the hose. Description " .
Is the inspection result normal? YES >> GO TO 20.
NO >> Repair or replace hoses and tubes. YES >> GO TO 21.
NO >> Repair or replace hose, tube or fuel filler tube. Component Inspection (Refueli
ng EVAP vapor cut valve) " .
Is the inspection result normal? YES >> GO TO 22.
NO >> Replace refueling EVAP vapor cut valve with fuel tank. Fuel Level Sensor Signal Inspection " .
Is the inspection result normal? YES >> GO TO 23.
Page 1645 of 4331
EC
NP
O
NO >> Replace fuel level sensor unit. Diagnosis Procedure " .
>> INSPECTION END
Component Inspection (Fuel filler cap) INFOID:0000000004803116YES >> INSPECTION END
NO >> GO TO 2.
Page 1646 of 4331
EC-290< COMPONENT DIAGNOSIS >
[HR16DE]
P0442 EVAP CONTROL SYSTEM
4. Blow air into port A and check t hat it flows freely out of port B.
5. Block port B.
6. Blow air into port A and check that there is no leakage.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace drain filter. PBIB3641E
Page 1647 of 4331
EC
NP
O
P0443 EVAP CANISTER PURGE VOLU
ME CONTROL SOLENOID VALVE
Description INFOID:0000000004780175
The EVAP canister purge volume control solenoid valve is used to
control the flow rate of fuel v apor from the EVAP canister. The EVAP
canister purge volume control solenoid valve is moved by ON/OFF
pulses from the ECM. The longer the ON pulse, the greater the
amount of fuel vapor that will flow through the valve.
DTC Logic INFOID:0000000004780176
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE YES >> GO TO 2.
NO >> GO TO 4. YES >> Go to
EC-293, " Diagnosis Procedure " .
NO >> GO TO 3.
Page 1648 of 4331
OK >> INSPECTION END
NG >> Go to EC-293, " Diagnosis Procedure " .
YES >> Go to
EC-293, " Diagnosis Procedure " .
NO >> GO TO 5. YES >> Go to
EC-293, " Diagnosis Procedure " .
NO >> INSPECTION END ECM
Ground Voltage (V)
Connector Terminal
F11 43
(Fuel tank temperature sensor signal) Ground 3.1 - 4.0