Page 1337 of 4331
DI
N
O P
A/T Indicator Does
Not Illuminate INFOID:0000000004307023 B
Page 1338 of 4331
Self-
Diagnosis Mode of Combination Meter " .
Are all segments displayed? YES >> GO TO 2.
NO >> Replace combination meter. Refer to IP-12, " Removal
and Installation " .
" CONSULT-III Function (METER/M&A) " .
Self - diagnostic results content
No malfunction detected>>GO TO 3.
Malfunction detected>> Check applicable parts, and repair or replace as necessary. OK >> Replace combination meter. Refer to
IP-12, " Removal and Installation " .
NG >> GO TO 4. CONSULT-III Functi
on (TRANSMISSION) " .
OK or NG OK >> Check TCM input/output signal. Repair or repl
ace malfunctioning part, if necessary. Refer to AT-31, " Input/Output Signal of TCM " .
NG >> Check applicable part, and repair or replace as necessary.
Page 1339 of 4331
DI
N
O P
CVT INDICATOR
System Description INFOID:0000000004307024
The TCM receives CVT indicator signals from the CVT unit (early production) or the park/neutral position
(PNP) switch (late production). The TCM then sends CVT position indicator signals to the combination meter
via CAN communication lines. The combination meter indicates the received shift position.
Schematic INFOID:0000000004673020 B
Page 1340 of 4331
Page 1341 of 4331
Page 1342 of 4331
Page 1343 of 4331

CVT INDICATOR
DI-41
< SERVICE INFORMATION >
C
D E
F
G H
I
J
L
M A
B DI
N
O P
Perform self-diagnosis of combination meter. Refer to
DI-10, " Self-
Diagnosis Mode of Combination Meter " .
Are all segments displayed? YES >> GO TO 2.
NO >> Replace combination meter. Refer to IP-12, " Removal
and Installation " .
2.
CHECK COMBINATION METER (CONSULT-III)
1. Connect CONSULT-III.
2. Select “METER/M&A” on CONSULT-III, and perform se lf-diagnosis of combination meter. Refer to DI-12," CONSULT-III Function (METER/M&A) " .
Self - diagnostic results content
No malfunction detected>>GO TO 3.
Malfunction detected>> Check applicable parts, and repair or replace as necessary. 3.
CHECK COMBINATION METER INPUT SIGNAL
Use “DATA MONITOR” of “METER/M&A” on CONSULT-II I. Confirm each indication on the monitor when oper-
ating the CVT selector lever.
OK or NG OK >> Replace combination meter. Refer to
IP-12, " Removal and Installation " .
NG >> GO TO 4. 4.
CHECK SELF-DIAGNOSIS RESULTS OF TCM
Perform self-diagnosis of TCM. Refer to CVT-230, " CONSULT-III Function (TRANSMISSION) " .
OK or NG OK >> Check TCM input/output signal. Repair or repl
ace malfunctioning part, if necessary. Refer to CVT-204, " Input/Output Signal of TCM " .
NG >> Check applicable part, and repair or replace as necessary. SKIB1206J
CONSULT-III dis-
play Switch operation Operation status
P RANGE IND P range position ON
Except for P range position OFF
R RANGE IND R range position ON
Except for R range position OFF
N RANGE IND N range position ON
Except for N range position OFF
D RANGE IND D range position ON
Except for D range position OFF
L RANGE IND L range position ON
Except for L range position OFF
Page 1344 of 4331