2007 TOYOTA SIENNA Service Repair Manual

fusesspare wheelbeltbrakescabin filterreset infotainment system
Popular search:
relayservice indicatorset clocksecurityfuel capTransaxleheight adjustment
Previous
Next
Load previous 8 pages

Page 937 of 3000

TOYOTA SIENNA 2007 Service Repair Manual EM–1282GR-FE ENGINE MECHANICAL – ENGINE UNIT EM (b) Gradually heat the piston to approximately 80C (176 F). (c) Coat the piston pin with engine oil. (d) Align the front marks of the piston and

Page 938 of 3000

TOYOTA SIENNA 2007 Service Repair Manual 2GR-FE ENGINE MECHANICAL – ENGINE UNITEM–129 EM (b) Using a piston ring expander, install the compression ring as shown in the illustration. (c) Position the piston rings so that the ring ends

Page 939 of 3000

TOYOTA SIENNA 2007 Service Repair Manual EM–1302GR-FE ENGINE MECHANICAL – ENGINE UNIT EM (b) Install the upper bearing. (1) Install the upper crankshaft bearings to the cylinder block as shown in the illustration. NOTICE: • Do not a

Page 940 of 3000

TOYOTA SIENNA 2007 Service Repair Manual 2GR-FE ENGINE MECHANICAL – ENGINE UNITEM–131 EM (b) Confirm the projection and numbers of the main bearing caps and install the bearing caps on the cylinder block. HINT: A number is marked on

Page 941 of 3000

TOYOTA SIENNA 2007 Service Repair Manual EM–1322GR-FE ENGINE MECHANICAL – ENGINE UNIT EM (h) Install the 8 crankshaft bearing cap bolts to the outside positions. (i) Install the crankshaft bearing cap bolts. HINT: The crankshaft beari

Page 942 of 3000

TOYOTA SIENNA 2007 Service Repair Manual 2GR-FE ENGINE MECHANICAL – ENGINE UNITEM–133 EM (n) Check the crankshaft thrust clearance (See page EM-118). 9. INSTALL CONNECTING ROD BEARING (a) Install the connecting rod bearing to the conn

Page 943 of 3000

TOYOTA SIENNA 2007 Service Repair Manual EM–1342GR-FE ENGINE MECHANICAL – ENGINE UNIT EM (c) Using a piston ring compressor, push the correctly numbered piston and connecting rod assembly into the cylinder with the front mark of the

Page 944 of 3000

TOYOTA SIENNA 2007 Service Repair Manual 2GR-FE ENGINE MECHANICAL – ENGINE UNITEM–135 EM 11. INSTALL INTAKE VALVE GUIDE BUSH (a) Using a caliper gauge, measure the intake valve guide bush bore diameter of the cylinder head. Cylinder b
Load next 8 pages
Page:   < prev 1-10 ... 905-912 913-920 921-928 929-936 937-944 945-952 953-960 961-968 969-976 ... 3000 next >
engine oilfuel fill door releasecenter consoleservice resettechnical datafuse chart
Popular search:
HosesDrum brakeheadlightspower steeringphonediagnosisFuel System