Page 2105 of 3000
PP–50PREPARATION – DIFFERENTIAL
PP
SSM
Toyota Genuine Seal Packing 1281,
Three Bond 1281 or equivalent
Page 2106 of 3000
PREPARATION – AXLEPP–49
PP
RECOMMENDED TOOLS
HINT:
Trox is a registered trademark of Trxtron Inc.
09011-12301 Socket Wrench 30 mm
09042-00010 Torx Socket T30
09905-00013 Snap Ring Pliers
Page 2107 of 3000
PP–50PREPARATION – AXLE
PP
EQUIPMENT
To r q u e w r e n c h
Dial Indicator with magnetic base
Page 2108 of 3000
PREPARATION – SUSPENSIONPP–51
PP
RECOMMENDED TOOLS
09011-12301 Socket Wrench 30 mm
09040-00011 Hexagon Wrench Set
(09043-20060) Socket Hexagon Wrench 6
Page 2109 of 3000
PP–52PREPARATION – SUSPENSION
PP
EQUIPMENT
To r q u e w r e n c h
Dial indicator with magnetic base
Wheel balancer
Tire pressure gauge
Alignment tester
Camber-caster-kingpin gauge
Toe-in gauge
Angle gauge
Drill
Plastic hammer
Engine Sling Device
Universal Engine Lifter
Chain Block
Slide calipers
Wooden block
Page 2110 of 3000

DF–10DIFFERENTIAL – REAR DIFFERENTIAL CARRIER ASSEMBLY
DF
REMOVAL
1. REMOVE REAR WHEEL
2. REMOVE EXHAUST PIPE ASSEMBLY
HINT:
(See page EX-8)
3. REMOVE PROPELLER WITH CENTER BEARING
SHAFT ASSEMBLY
HINT:
(See page PR-3)
4. REMOVE REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (10 mm), remove the filler
plug and gasket.
5. REMOVE REAR DIFFERENTIAL DRAIN PLUG
(a) Using a hexagon wrench (10 mm), remove the drain
plug and gasket, and drain the oil.
6. REMOVE REAR SPEED SENSOR LH
HINT:
Removal procedure or RH side is the same as that or LH
side. (See page DS-21)
7. REMOVE REAR AXLE SHAFT NUT LH
HINT:
Removal procedure or RH side is the same as that or LH
side. (See page DS-21)
8. REMOVE REAR DRIVE SHAFT ASSEMBLY LH
HINT:
Removal procedure or RH side is the same as that or LH
side. (See page DS-21)
9. REMOVE REAR DIFFERENTIAL CARRIER
ASSEMBLY
(a) Support the rear differential carrier assembly with a
jack.
(b) Remove the bolt and nut, separate the No. 1 rear
differential support.
D030574
Page 2111 of 3000
DIFFERENTIAL – REAR DIFFERENTIAL CARRIER ASSEMBLYDF–11
DF
(c) Remove the 2 bolts, separate the rear differential
support assembly.
NOTICE:
Be careful not to drop the rear differential carrier
assembly.
10. REMOVE REAR DIFFERENTIAL SUPPORT
ASSEMBLY
(a) Remove the 3 bolts and rear differential support
assembly.
11. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER
(a) Remove the 2 bolts and rear differential dynamic
damper from the No. 1 rear differential support.
12. REMOVE NO. 1 REAR DIFFERENTIAL SUPPORT
(a) Remove the 2 bolts, 2 nuts and No. 1 rear
differential support.
INSTALLATION
1. INSTALL NO. 1 REAR DIFFERENTIAL SUPPORT
(a) Install the No. 1 rear differential support to the rear
differential carrier assembly with the 2 bolts and 2
nuts.
Torque: 85 N*m (867 kgf*cm, 63 ft.*lbf)
HINT:
Hold the bolt and tighten the nut.
D030575
D030577
D030576
C097682
C097682
Page 2112 of 3000

DF–12DIFFERENTIAL – REAR DIFFERENTIAL CARRIER ASSEMBLY
DF
2. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
(a) Install the rear differential dynamic damper to the
No. 1 rear differential support with the 2 bolts.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
3. INSTALL REAR DIFFERENTIAL SUPPORT
ASSEMBLY
(a) Install the rear differential support assembly to rear
differential carrier assembly with the 3 bolts.
Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf)
4. INSTALL REAR DIFFERENTIAL CARRIER
ASSEMBLY
(a) Jack up the rear differential carrier assembly.
(b) Install the rear differential carrier assembly with the
2 bolts.
Torque: 106 N*m (1,081 kgf*cm, 78 ft.*lbf)
(c) Connect the No. 1 rear differential support with the
bolt and nut.
Torque: 95 N*m (969 kgf*cm, 70 ft.*lbf)
HINT:
Tighten the bolt.
5. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
HINT:
Install procedure of RH side is the same as that of LH
side. (See page DS-26)
6. INSTALL REAR AXLE SHAFT NUT LH
HINT:
Install procedure of RH side is the same as that of LH
side. (See page DS-26)
7. INSTALL REAR SPEED SENSOR LH
HINT:
Install procedure of RH side is the same as that of LH
side. (See page DS-26)
8. INSTALL PROPELLER WITH CENTER BEARING
SHAFT ASSEMBLY (See page PR-9)
D030576
D030577
D030575
D030574