2005 NISSAN X-TRAIL Service Repair Manual

belt change language rims driver seat adjustment air filter child lock

Load previous 8 pages

Page 3433 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual NAVIGATION SYSTEM
AV-91
C
D
E
F
G
H
I
J
L
MA
B
AV

Reverse Signal CheckEKS00F3G
1. REVERSE LAMP CHECK
Turn the ignition switch ON.
With the A/T selector lever in R-position, does “R” in the shif

Page 3434 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual AV-92
NAVIGATION SYSTEM

2. RGB HARNESS CHECK
1. Turn the ignition switch OFF.
2. Disconnect NAVI control unit connector and display connector.
3. Check continuity as following.
When the screen look

Page 3435 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual NAVIGATION SYSTEM
AV-93
C
D
E
F
G
H
I
J
L
MA
B
AV

3. RGB SIGNAL CHECK
1. Connect NAVI control unit connector and display connector.
2. Turn the ignition switch ON.
3. Display “Color bar” by “C

Page 3436 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual AV-94
NAVIGATION SYSTEM

2. RGB AREA SIGNAL CHECK
1. Connect NAVI control unit connector and display connector.
2. Turn ignition switch ON.
3. Push “INFO” switch.
4. Check the signal between NAVI

Page 3437 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual NAVIGATION SYSTEM
AV-95
C
D
E
F
G
H
I
J
L
MA
B
AV

Guide Sound Is Not HeardEKS00F3K
1. CHECK VOICE GUIDE SETTING
While driving in the dark pink route, voice guide does not operate.
NOTE:
Voice guide

Page 3438 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual AV-96
NAVIGATION SYSTEM

4. VOICE CHANGE RELAY CIRCUIT CHECK 1
1. Turn ignition switch OFF.
2. Disconnect transfer unit connector and voice change relay connector.
3. Check continuity between transfe

Page 3439 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual NAVIGATION SYSTEM
AV-97
C
D
E
F
G
H
I
J
L
MA
B
AV

7. VOICE CHANGE RELAY ON SIGNAL CHECK
1. Connect voice transfer unit connector.
2. Turn ignition ON.
3. Push “VOICE” switch.
4. Check voltage b

Page 3440 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual AV-98
NAVIGATION SYSTEM

Example of Symptoms Judged Not MalfunctionEKS00F3N
BASIC OPERATIONS
VEHICLE MARKS
Symptom Possible cause Remedy
No image comes on.The brightness adjustment is at the lowest s

AV-98
NAVIGATION SYSTEM

Example of Symptoms Judged Not MalfunctionEKS00F3N
BASIC OPERATIONS
VEHICLE MARKS
Symptom Possible cause Remedy
No image comes on.The brightness adjustment is at the lowest set-
ting.Adjust to brighter setting.
No map comes on the screen.No map DVD-ROM is inserted, or it is inserted
upside down.Insert the DVD-ROM correctly.
The map display mode is switched off. Push the “MAP” button.
No voice guidance is available. or
The volume is not high enough.The volume is not set correctly or it is turned
off.Adjust the volume correctly.
The screen is too dim. The move-
ment is slow.The temperature in the vehicle is low. Wait for the temperature to rise.
There are darker or brighter dots
in the display.It is inherent to LC displays. This is not malfunction.
Symptom Possible cause Remedy
The location names differ between
PLAN VIEW and BIRDVIEW
® .This is because the displayed information is
reduced so that the screen does not become
too crowded. There is also a chance that
names of the roads or locations will be repeat-
edly displayed. The name appearing on the
screen may be different because of the pro-
cessing procedure.It should not be regarded as malfunction.
The vehicle mark is not shown
correctly.The vehicle might have moved with the ignition
off, for example on a ferry boat or car trans-
porter.Drive the vehicle with GPS on for some dis-
tance.
The screen does not switch to
night mode even after turning the
headlights on.The last time the lights were turned on, your
setting was in daytime mode.Turn the headlights on again, go to DISPLAY
SETTINGS screen and set it to the night
mode.
The map does not scroll even
when the vehicle is traveling.The display is not switched to the map screen. Push the “MAP” button.
The vehicle mark does not show
up.The display is not switched to the map screen. Push the “MAP” button.
GPS indicator on the screen
remains gray.GPS signals are not received because the vehi-
cle is indoors or in the shade of buildings.Move the vehicle outdoors with a clear view of
the sky.
GPS satellites are in poor locations.Wait for the satellites to move to better loca-
tions.
The location of the vehicle mark
does not match the actual posi-
tion.Driving on slippery road surface If the vehicle mark does not move to the cor-
rect position even after the vehicle has been
driven for approximately 10 km (6 miles),
adjust the current location. If necessary, adjust
the moving speed of the vehicle. Driving on slanted area
Rough or violent driving.If the position maker does not move to the cor-
rect position even after the vehicle has been
driven for approximately 10 km (6 miles),
adjust the current location.
GPS indicator remains gray.Please check the GPS indicator on the screen
to see if it remains gray.
Errors (gain or loss) result in calculating the
speed from the speed pulse because the vehi-
cle has tire chains on, or the system was trans-
ferred to a different vehicle.It will move by driving the vehicle for 30 min-
utes [in case it is running at 30 km/h (19
MPH)]. If you still notice errors, adjust moving
speed.
The map data has an error or is incomplete (if
the location error always happens in the same
area).Please wait for the updated Map

Load next 8 pages

Page: < prev 1-10 ... 3401-3408 3409-3416 3417-3424 3425-3432 3433-3440 3441-3448 3449-3456 3457-3464 3465-3472 ... 4560 next >

deactivate airbag park assist boot check engine light key fob fuses