2005 NISSAN X-TRAIL Service Repair Manual

Page 2713 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual REPAIR FOR COMPONENT PARTS
AT-449
[ALL]
D
E
F
G
H
I
J
K
L
MA
B
AT
 
DISASSEMBLY
Disassemble upper, inter and lower bodies.
Bolt length, number and location:
f: Reamer bolt and nut.
1. Remove bolts a,

Page 2714 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual AT-450
[ALL]
REPAIR FOR COMPONENT PARTS
 
3. Remove O-rings from solenoid valves and terminal body.
4. Place control valve upper body facedown, and remove bolts b ,
and nut f .
CAUTION:
Remove bolts w

Page 2715 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual REPAIR FOR COMPONENT PARTS
AT-451
[ALL]
D
E
F
G
H
I
J
K
L
MA
B
AT
 
9. Remove control valve inter body from control valve upper body.
10. Check to see that steel balls are properly positioned in contr

Page 2716 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual AT-452
[ALL]
REPAIR FOR COMPONENT PARTS
 
Check to see that retainer plates are properly positioned in con-
trol valve upper body.
Oil Strainer
Check wire netting of oil strainer for damage.
Shift S

Page 2717 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual REPAIR FOR COMPONENT PARTS
AT-453
[ALL]
D
E
F
G
H
I
J
K
L
MA
B
AT
 
Oil Cooler Relief Valve Spring
Check springs for damage or deformation.
Measure free length and outer diameter. Refer to AT- 5 3 0

Page 2718 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual AT-454
[ALL]
REPAIR FOR COMPONENT PARTS
 
d. Place control valve inter body as shown in the figure (side of
control valve lower body face up). Install steel balls in their
proper positions.
e. Install

Page 2719 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual REPAIR FOR COMPONENT PARTS
AT-455
[ALL]
D
E
F
G
H
I
J
K
L
MA
B
AT
 
2. Install O-rings to solenoid valves and terminal body.
CAUTION:
Do not reuse O-rings.
Apply ATF to O-rings.
3. Install and tight

Page 2720 of 4555

NISSAN X-TRAIL 2005  Service Repair Manual AT-456
[ALL]
REPAIR FOR COMPONENT PARTS
 
b. Install solenoid valve assembly and line pressure solenoid valve
on control valve assembly.
c. Tighten bolts a , c  and g  to specified torque.
d. Set oil