1997 SUBARU LEGACY Service Repair Manual

Page 1241 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0833
3. RACK PISTON SEAL RING AND O-RING
Removal
Using a sharp-edged, long rod, remove seal ring and
O-ring from rack piston.
CAUTION:
Be careful not to scratch outer surface of rack piston
and se

Page 1242 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0844
D: ASSEMBLY
1. RACK ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No. 003608001)
1) Attach steering body to ST as shown. Apply a coat of
grease to needle bearing.
ST 926200000 ST

Page 1243 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0891
5) Apply a coat of grease to grooves in rack, sliding sur-
face of sleeve and sealing surface of piston. Install ST on
the end of steering body cylinder. Then insert rack into
steering body fr

Page 1244 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0850
9) Attach ST to rack cylinder. Using a press, install
back-up ring and oil seal.
NOTE:
Press ST until its groove is aligned with end of holder.
ST 34099FA030 INSTALLER & REMOVER
G4M0967
10) Us

Page 1245 of 3342

SUBARU LEGACY 1997  Service Repair Manual B4M0669A
2. VALVE ASSEMBLY
1) Remove traces of sealer, oil, rust, etc., from mating
surfaces of valve housing and steering body.
2) Position a shim in graded portion of steering body pin-
ion housing,

Page 1246 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0098
7. Pipe Assembly (Power Steering
System)
A: REMOVAL
1. LHD MODEL
1) Disconnect battery minus terminal.
G4M0099
2) Lift vehicle and remove jack-up plate.
3) Remove one pipe joint at the center

Page 1247 of 3342

SUBARU LEGACY 1997  Service Repair Manual G4M0101
5) Disconnect pipe C⋅D from pipe (on the gearbox side).
CAUTION:
When disconnecting pipe C⋅D, use two wrenches to
prevent deformities.
Be careful to keep pipe connections free from for-

Page 1248 of 3342

SUBARU LEGACY 1997  Service Repair Manual B4M0672A
4) Remove clamp E from pipes C and D.
5) Remove flare nuts from control valve of gearbox
assembly, and then disconnect pipe C⋅D.
CAUTION:
When disconnecting pipe C⋅D, use two wrenches to