1997 SUBARU LEGACY Service Repair Manual

Page 1169 of 3342

SUBARU LEGACY 1997  Service Repair Manual B4M0774
8) Align alignment marks on shaft and outer race, and
install outer race.
9) Install circlip in the groove on FTJ outer race.
CAUTION:
Pull the shaft lightly and assure that the circlip is com

Page 1170 of 3342

SUBARU LEGACY 1997  Service Repair Manual 16) Cut off band with an allowance of about 10 mm (0.39
in) left from the clip and bend this allowance over the clip.
CAUTION:
Be careful to that the end of the band is in close con-
tact with clip.
1

Page 1171 of 3342

SUBARU LEGACY 1997  Service Repair Manual 5) Connect transverse link to housing.
Tightening torque (self-locking nut):
49±10 N⋅m (5.0±1.0 kg-m, 36±7 ft-lb)
CAUTION:
Use a new self-locking nut.
6) Install stabilizer bracket.
7) While depr

Page 1172 of 3342

SUBARU LEGACY 1997  Service Repair Manual G3M0050
6) Align DOJ and differential splines.
7) Push housing to insert DOJ into differential.
NOTE:
Make sure DOJ is inserted properly.
8) Connect crossmember reinforcement lower to cross-
member (4

Page 1173 of 3342

SUBARU LEGACY 1997  Service Repair Manual 5. Replacement of Front DOJ and UFJ
Boots
A: REMOVAL
1) Disconnect ground cable from battery.
2) Jack-up vehicle, support it with safety stands (rigid
rocks), and remove front wheel cap and wheels.
NO

Page 1174 of 3342

SUBARU LEGACY 1997  Service Repair Manual 6. Replacement of Rear DOJ and BJ
Boots
A: REMOVAL
1) Disconnect ground cable from battery.
2) Lift-up vehicle, and remove rear wheel cap and wheels.
NOTE:
Axle nut need not be removed.
3) Remove A.B.

Page 1175 of 3342

SUBARU LEGACY 1997  Service Repair Manual B4M0549A
2) Using ST, install DOJ into differential.
ST 28099PA090 SIDE OIL SEAL PROTECTOR
B4M0550A
3) Insert DOJ spline end into bore of side oil seal, and
remove ST.
CAUTION:
Do not allow DOJ spline

Page 1176 of 3342

SUBARU LEGACY 1997  Service Repair Manual B4M0051
7. Full Wheel Cap
A: REMOVAL
Pry off the full wheel cap with a wheel cap remover inserted
between openings in the cap.
B: INSTALLATION
Align the valve hole in the wheel cap with the valve on t