1998 OPEL FRONTERA Workshop Manual

low oil pressurefog lightclock resettransmission oildashboardECU
Popular search:
oil typetiming beltoil dipstickfog lightclockfog light bulbrun flat
Previous
Next
Load previous 8 pages

Page 265 of 6000

OPEL FRONTERA 1998 Workshop Manual 7. Install drive plate bolt by using drive plate holder J-7624 (1) to prevent the drive plate from rotating. Tighten the drive plate bolt to the specified torque. Torque: 13 Nꞏm (113 lb in)

Page 266 of 6000

OPEL FRONTERA 1998 Workshop Manual Legend (1) Drive Plate Bolt (2) Drive Plate (3) Shim (4) Snap Ring (5) Pulley Assembly (6) Screw (7) Field Coil (8) Through Bolt (9) Shaft Seal Assembly (10) Gasket (11) Front Cylinder Head(12) O-Ring

Page 267 of 6000

OPEL FRONTERA 1998 Workshop Manual Removal 1. Remove drive plate bolt by using drive plate holder J-7624 (1) to prevent the drive plate from rotating. 2. Remove drive plate by using drive plate puller J-33944-A (2) and

Page 268 of 6000

OPEL FRONTERA 1998 Workshop Manual 6. Loosen three screws and remove the field coil. 7. Remove snap ring by using snap ring pliers.8. Remove shaft seal assembly (2) by using shaft seal remover J-33942 (1). Engage the remover hook w

Page 269 of 6000

OPEL FRONTERA 1998 Workshop Manual 10. Remove front cylinder head. 11. Remove o-ring. Alternately tap the projections on the circumference of th front cylinder head with a screwdriver and a plastic hammer to remove t

Page 270 of 6000

OPEL FRONTERA 1998 Workshop Manual Installation 1. Install cylinder and shaft assembly. Clamp the cylinder shaft assembly in a vise. The rear side of the cylinder shaft assembly must be facing up. 2. Install rear suction valve.

Page 271 of 6000

OPEL FRONTERA 1998 Workshop Manual 8. Install front valve plate. Apply a coat of new compressor oil to the new valve plate. Install the valve plate to the suction valve by aligning it with the spring pin. NOTE Do not m

Page 272 of 6000

OPEL FRONTERA 1998 Workshop Manual 13. Install shaft seal assembly. Clean the sealing portion of the compressor and shaft seal (2). Install the shaft seal guide J-34614 (1) onto the end of the drive shaft. Apply new comp
Load next 8 pages
Page:   < prev 1-10 ... 233-240 241-248 249-256 257-264 265-272 273-280 281-288 289-296 297-304 ... 6000 next >
lengthfuse box locationfuel fill door releaselow beamfog light bulbESP inoperative
Popular search:
air conditionwiper fluidbrake fluidground clearancepressure reliefseat adjustmentmaintenance