Page 3297 of 6000
8F–102BODY STRUCTURE
Installation
1. Install the rear quarter side glass.
Clean the bonding surfaces of both the glass and the
body panel.
Install the fasteners (1) to the fixed positions of the
glass and the body panel.
641RS006
Always use new fasteners.
Be absolutely sure to apply glass primer (2) to the side
glass.
Apply a sealing adhesive (1) to the glass
circumference.
641RS007
Page 3298 of 6000
8F–103 BODY STRUCTURE
Apply PVC primer (4) to the A clip portion.
641RS008
Insert the fixing clip on the side glass into the body
panel.
Push the side glass against the body panel and bond
them.
Cure the adhesive at a temperature of 20~30C
(68~86
F) for 24 hours.
Check that the rear quarter side glass does not leak
water.
2. Install the valve assembly.
3. Install the ventilation assembly.
4. Install the rear quarter upper trim panel.
Page 3299 of 6000
8F–104BODY STRUCTURE
Tailgate Glass
Parts Location
682RW008
Legend
(1) Tailgate Glass Moulding
(2) Tailgate Glass
(3) Tailgate Glass Clip(4) Glass Moulding
(5) Clip
(6) Body Panel
Removal
1. Remove battery ground cable.
2. Remove tailgate trim panel.
3. Remove tailgate sash trim cover (RH only).
Remove the tailgate frame cover. Refer to Exterior /
Interrior Trim in this section
4. Remove tailgate glass.
Refer to Windshield removal procedure in this
section.
682RS007
5. Remove tailgate glass clip.
Page 3300 of 6000
8F–105 BODY STRUCTURE
Installation
682RW009
Legend
(1) Glass Moulding
(2) Tailgate Glass
(3) Clip(4) Sealing Adhesive
(5) Body Panel
(6) Tailgate Frame
1. Install the tailgate glass clip.
682RS008
2. Install the tailgate glass (2).
Clean the bonding surfaces of both the tailgate
glass and the tailgate panel.
Be absolutely sure to apply glass primer to the
tailgate glass and PCV primer to the glass moulding
(1).
Apply a sealing adhesive to the circumference of
the tailgate glass as shown.
Insert the clip of the tailgate glass A portion into the
tailgate panel hole to position the glass.
Install the new tailgate glass clip to the clip of the
tailgate glass B portion while sliding it, and bond the
glass to the tailgate panel by applying pressure.
Always use new tailgate glass clips.
Cure the bonding at a temperature of 20~30C
(68
86F) for 24 hours.
Check that the tailgate glass does not leak water.
Page 3301 of 6000
8F–106BODY STRUCTURE
Main Data and Specifications
Torque Specifications
E10RW020
Page 3302 of 6000
8F–107 BODY STRUCTURE
E10RW019
Page 3303 of 6000
8F–108BODY STRUCTURE
E10RX007
Page 3304 of 6000
8F–109 BODY STRUCTURE
E10RW021