Page 3401 of 6000
8J–22EXTERIOR/INTERIOR TRIM
Roof Side Trim Cover (Short Wheel Base)
Roof Side Trim Cover and Associated
Parts
643RW006
Legend
(1) Front Pillar Trim Cover
(2) Roof Side Trim Cover
(3) Assist Grip (Passenger Seat Side)
(4) Rear Quarter Upper Trim Cover
Removal
1. Remove the assist grip.
2. Remove the roof side trim cover (9).
Turn up the finisher (10) and pry the trim cover
retainers free from the body panel.
643RS005
Installation
To install, follow the removal steps in the reverse order.
Page 3402 of 6000
EXTERIOR/INTERIOR TRIM8J–23
Front Pillar Trim Cover
Front Pillar Trim Cover and
Associated Parts
743RS003
Legend
(1) Roof Side Trim Panel
(2) Assist Grip
(3) Front Pillar Trim Panel
Removal
1. Remove the front pillar assist grip(1).
Open the both sides of the assist grip cover (2) and
remove the fixing screws and the front pillar assist
grip.
743RW003
2. Remove the front pillar trim cover (3).
Turn up the finisher (4) and pry the trim cover
retainers free from the body panel.
635RW001
Installation
To install, follow the removal steps in the reverse order.
Page 3403 of 6000
8J–24EXTERIOR/INTERIOR TRIM
Center Pillar Assist Grip
Parts Location
743RS004
Legend
(1) Center Pillar Assist Grip
Removal and Installation
Refer to the Center Pillar and Roof Side Trim Cover in this
section.
Assist Grip
Parts Location
743RS005
Legend
(1) Assist Grip
Removal and Installation
Refer to the Front Pillar Trim Cover in this section.
Page 3404 of 6000
EXTERIOR/INTERIOR TRIM8J–25
Fuel Filler Lid Opener Cable
Fuel Filler Lid Opener Cable and Associated Parts
686RW008
Legend
(1) Rear End Floor Trim Cover
(2) Fuel Filler Lid Opener Cable (LꞏWꞏB)
(3) To Lever
(4) Cable
(5) Marking
(6) Clip
(7) To Door(8) Fuel Filler Lid Opener Cable (SꞏWꞏB)
(9) Chassis Harness
(10) Center Console Assembly
(11) Fuel Filler Lid Opener
(12) Front Seat (RH)
(13) Center Pillar Lower Trim Cover
(14) Rear Door Sill Plate (RH)
(15) Luggage Side Trim Panel (RH)
Removal
1. Disconnect the battery ground cable.
2. Remove the front seat (RH).
3. Remove the rear door sill plate (RH).
4. Remove the center pillar lower trim cover.
5. Remove the rear end floor trim panel.6. Remove the luggage side trim panel (RH).Refer to the Interior Trim Panels in this section.
Page 3405 of 6000
8J–26EXTERIOR/INTERIOR TRIM
7. Remove the fuel filler lid opener(1).
Remove two opener fixing screws and disconnect
the cable(2).
686RW007
8. Remove the center console assembly.
9. Remove the fuel filler lid opener cable.
Roll up the floor carpet and remove the clips of the
chassis harness and body panel to pull out the
cable toward the fuel filler lid.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Insert the opener cable(2) into the body panel(1)
securely.
686RS002
2. Install the cable and clips to its original position to the
chassis harness and the body panel.
3. Check that the opener operates smoothly.
Fuel Filler Door
Parts Location
686RS003
Legend
(1) Fuel Filler Door
Removal
1. Remove the fuel filler door.
Installation
1. Install the fuel filler door.
Page 3406 of 6000
EXTERIOR/INTERIOR TRIM8J–27
Rocker Protector (Without Wheel Opening Extension)
Rocker Protector (Without Wheel Opening Extension) and Associated Parts
603RW015
Legend
(1) Rear Rocker Protector
(2) Inner Liner
(3) Spare Nut
(4) Fixing Screw
(5) Rocker Protector
(6) Outer Side Panel
(7) Outer Wheel House Panel(8) Fixing Clip
(9) Outer Rocker Panel
(10) Door Panel
(11) Front Rocker Protector
(12) Clip (W/Rocker Protector)
(13) Fender Panel
(14) Short Wheel Base
Removal
1. Remove the rear rocker protector.
2. Remove the front rocker protector.
Installation
To install, follow the remove steps in the reverse order.
Page 3407 of 6000
8J–28EXTERIOR/INTERIOR TRIM
Wheel Opening Extension and Rocker Protector Assembly
Wheel Opening Extension, Rocker Protector Assembly and Associated Parts
620RW005
Legend
(1) Front Wheel Opening Extension Assembly
(2) Front Rocker Protector Assembly
(3) Rear Rocker Protector Assembly (Only LWB)
(4) Rear Door Wheel Opening Extension
Assembly (Only LWB)(5) Rear Quarter Wheel Opening Extension
Assembly (Only LWB)
(6) Rear Wheel Opening Extension Assembly
(Only SWB)
Removal
1. Remove the front wheel opening extension(2).
Let a 5mm drill(3) go through four blind rivets(5) to
disengaged riveted portions.
Remove two screws and disengage five clips (6),
then remove the front wheel opening extension
assembly.
Page 3408 of 6000

EXTERIOR/INTERIOR TRIM8J–29
620RS005
2. Remove the rear quarter wheel opening extension
assembly (Only LWB).
Let a 5mm drill go through six blind rivets to
disengage riveted portions.
Disengage four clips, remove two screws, and
remove the rear quarter wheel opening extension
assembly.
3. Remove the rear wheel opening extension assembly
(Only SWB).
Let a 5mm drill go through four blind rivets to
disengage riveted portions. Remove two screws,
disengage eight clips, and remove the rear wheel
opening extension assembly.
Remove two fixing nuts (upper) and four fixing bolts
(lower).
4. Remove the rear door wheel opening extension
assembly (Only LWB).
Let a 5mm drill go through a blind rivet to disengage
riveted portions.
Disengage three clips, peel off the bonded portions
with two double surface adhesive tape and the rear
door wheel opening extension assembly.
5. Remove the rear rocker protector assembly (Only
LW B ) .
Loosen and pull three clips, remove a rear screw,
and remove the rear rocker protector assembly.
6. Remove the front rocker protector assembly.
Loosen and pull four clips, and remove the front
rocker protector assembly.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Use a new 2–sided adhesive tape whenever installing
each wheel opening extension assembly and rocker
protector assembly. Using a white gasoline, clean the
places in advance where a 2–sided adhesive tape is
affixed. Also, install the clips, screws and blind rivets
in the order specified as shown in the figure.