Page 633 of 3371

AV-46
AUDIO
Revision: August 20072004 QX56
Removal and Installation of Front TweeterEKS007KZ
1. Remove tweeter grille. Refer to IP-10, "INSTRUMENT PANEL ASSEMBLY" .
2. Remove tweeter fasteners.
3. Disconnect connector and remove tweeter.
4. Installation is in the reverse order of removal.
Removal and Installation of Rear Door TweeterEKS007L0
1. Remove door finisher. Refer to EI-31, "DOOR FINISHER" .
2. Remove screws and remove tweeter.
3. Installation is in the reverse order of removal.
Removal and Installation of Center SpeakerEKS007L1
1. Remove cluster lid D. Refer to IP-12, "Cluster Lid D" .
2. Remove the screws and remove the center speaker.
3. Installation is in the reverse order of removal.
Removal and Installation of SubwooferEKS007L2
1. Remove front seat LH. Refer to SE-96, "Components" .
2. Remove the subwoofer bolts.
3. Disconnect the connector and remove the subwoofer.
4. Installation is in the reverse order of removal.
Removal and Installation of BOSE Speaker Amp.EKS007L3
1. Remove BCM. Refer to BCS-19, "Removal and Installation of BCM" .
WKIA1494E
WKIA1799E
Subwoofer mounting
bolts: 3.5 N·m (0.36 kg-m, 31 in-lb)
WKIA1496E
Page 634 of 3371

AUDIO
AV-47
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: August 20072004 QX56
2. Remove BOSE speaker amp. bracket screws and slide BOSE
speaker amp. down.
3. Disconnect connectors and remove BOSE speaker amp.
4. Installation is in the reverse order of removal.
Removal and Installation of Rear Audio Remote Control UnitEKS007L4
1. Carefully remove the rear audio remote control unit from the rear
roof console assembly.
CAUTION:
Wrap removal tool with clean shop cloth to prevent damage
to the headliner.
2. Disconnect connector and remove the rear audio control unit.
3. Installation is in the reverse order of removal.
Removal and Installation of Steering Wheel Audio Control SwitchesEKS007L5
1. Remove steering wheel. Refer to PS-8, "Removal and Installation" .
2. Remove steering wheel rear cover screws and remove steering wheel rear cover.
3. Remove steering wheel switch assembly screws and steering
wheel switches.
4. Installation is in the reverse order of removal.BOSE speaker amp.
mounting screws: 3.5 N·m (0.36 kg-m, 31 in-lb)
WKIA1605E
WKIA1201E
WKIA1226E
Page 635 of 3371
AV-48
AUDIO ANTENNA
Revision: August 20072004 QX56
AUDIO ANTENNAPFP:28200
System DescriptionEKS007L6
With the ignition switch in ACC or ON, power is supplied
through 10A fuse [No. 4, located in the fuse block (J/B)]
to audio unit terminal 10.
Ground is supplied through the case of the antenna amp.
When the radio switch is turned ON, antenna signal is supplied
through audio unit terminal 5
to the antenna amp. terminal 1.
Then the antenna amp. is activated.
The amplified radio signals are supplied to the audio unit through the antenna amp.
Page 636 of 3371
AUDIO ANTENNA
AV-49
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: August 20072004 QX56
Wiring Diagram — W/ANT —EKS007L7
WKWA2158E
Page 637 of 3371
AV-50
AUDIO ANTENNA
Revision: August 20072004 QX56
Location of AntennaEKS007L8
Window Antenna RepairEKS007L9
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on
each side.
When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
WKIA1800E
SEL250I
SEL122R
Page 638 of 3371
AUDIO ANTENNA
AV-51
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: August 20072004 QX56
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
ELEMENT REPAIR
Refer to GW-97, "Filament Repair" .
SEL252I
SEL253I
Page 639 of 3371
AV-52
DVD ENTERTAINMENT SYSTEM
Revision: August 20072004 QX56
DVD ENTERTAINMENT SYSTEMPFP:28184
Component Parts and Harness Connector LocationEKS007LA
WKIA4160E
Page 640 of 3371
DVD ENTERTAINMENT SYSTEM
AV-53
C
D
E
F
G
H
I
J
L
MA
B
AV
Revision: August 20072004 QX56
System DescriptionEKS007LB
Refer to Owner's Manual for DVD entertainment system operating instructions.
Power is supplied at all times
through 20A fuse (No. 31, located in the fuse and fusible link box)
to DVD player terminal 16.
With the ignition switch in the ACC or ON position, power is supplied
through 10A fuse [No. 4, located in the fuse block (J/B)]
to DVD player terminal 15.
Power is also supplied
from DVD player terminals 31 and 32
to video monitor terminals 11 and 12.
Ground is supplied
to DVD player terminal 22
through body grounds M57, M61 and M79.
Audio signals are supplied
through DVD player terminals 1, 2, 3 and 4
to audio unit terminals 34, 35, 36 and 37.
Video signals are supplied
through DVD player terminals 23, 24, 28 and 29
to video monitor terminals 5, 6, 7 and 8.