Page 857 of 2543
FRONT SEAT
COMPONENTS
BO±52± BODYFRONT SEAT
Page 858 of 2543
COMPONENTS (Cont'd)
± BODYFRONT SEATBO±53
Page 859 of 2543
REAR SEAT
COMPONENTS
BO±54± BODYREAR SEAT
Page 860 of 2543
COMPONENTS (Cont'd)
± BODYREAR SEATBO±55
Page 861 of 2543
SEAT BELT
COMPONENTS
BO±56± BODYSEAT BELT
Page 862 of 2543

SEAT BELT INSPECTION
Emergency Locking Retractor (ELR) and
Automatic Locking Retractor (ALR) type
1. RUNNING TEST (IN SAFE AREA)
for all seats:
(a) Fasten the front seat belts.
(b) Drive the car at 10 mph (16 km/h) and make a very hard stop.
(c) Check that the belt is locked and cannot be extended at this
time.
HINT: Conduct this test in a safe area. If the belt does not lock,
remove the belt mechanism assembly and conduct the fol-
lowing static check. Also, whenever installing a new belt as-
sembly, verify the proper operation before installation.
2. STATIC TEST
for all seats:
(a) Verify that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
(c) Tilt the retractor slowly.
(d) Verify that the belt can be pulled out at a tilt of 15 degrees or
less, and cannot be pulled out at over 45 degrees of tilt.
If a problem is found, replace the assembly.
except for driver's seat:
(e) Pull out the whole belt, release it slightly and then pull it out
again.
(f) Verify that the belt cannot be extended further.
If a problem is found, replace the assembly.
± BODYSEAT BELTBO±57
Page 863 of 2543
ROOF HEADLINING
COMPONENTS
BO±58± BODYROOF HEADLINING
Page 864 of 2543
ROOF HEADLINING REMOVAL
1. REMOVE THESE PARTS:
(a) Tonneau cover
(b) Luggage compartment mat
(c) Spare wheel cover
(d) Rear seat cushion
(e) Rear seatback
Torque: 25 NVm (260 kgfVcm, 19 ftVlbf)
(f) Removable roof stay RH and LH (Sport roof)
(g) Deck trim rear cover
(h) Removable roof holder RH and LH (Sport roof)
(i) Quarter wheel house cover
(j) Deck trim side board
(k) Front door scuff inside plate
(l) Speaker grille
(m) Rear quarter trim board
(n) Front seat outer belt
(o) Rear seat outer belt
± BODYROOF HEADLININGBO±59