2004 SUBARU FORESTER Service Repair Manual

brake pads replacement headrest tire pressure open bonnet fuel tank removal child restraint

Load previous 8 pages

Page 2465 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-6
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
General Description
5. OPERATION OF SHIFT SELECT LEVER
Make sure there is no abnormal noise, dragging or
contact pattern in each select lever range.
WAR

Page 2466 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-7
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
General Description
C: PREPARATION TOOL
1. SPECIAL TOOL
2. GENERAL TOOL
ILLUSTRATION TOOL NUMBER DESCRIPTION REMARKS
24082AA230
(Newly adopted tool)CART

Page 2467 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-8
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Electrical Components Location
4. Electrical Components Location
A: LOCATION
1. CONTROL MODULE
LHD MODEL
RHD MODEL
(1) Engine control module (ECM) (

Page 2468 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-9
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Electrical Components Location
LHD RHD
AT-00323
(1)
AT-00324
(2)
(3)
AT-00416
(3)
AT-00372
(4)
AT-00417

Page 2469 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-10
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Electrical Components Location
2. SENSOR
(1) Throttle position sensor (4) Rear vehicle speed sensor (6) ATF temperature sensor
(2) Front vehicle speed

Page 2470 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-11
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Electrical Components Location
3. SOLENOID
(1) Shift solenoid 1 (4) Low clutch timing solenoid (7) 2-4 brake timing solenoid
(2) Shift solenoid 2 (5) L

Page 2471 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-12
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Transmission Control Module (TCM) I/O Signal
5. Transmission Control Module (TCM) I/O Signal
A: ELECTRICAL SPECIFICATION
Check with ignition switch ON.

Page 2472 of 2870

SUBARU FORESTER 2004 Service Repair Manual 4AT(H4SO)-13
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Transmission Control Module (TCM) I/O Signal
Inhibitor
switch“2” range
switchB55 6Select lever in “2” range Less than 1
—
Select lever in a

4AT(H4SO)-13
AUTOMATIC TRANSMISSION (DIAGNOSTIC)
Transmission Control Module (TCM) I/O Signal
Inhibitor
switch“2” range
switchB55 6Select lever in “2” range Less than 1
—
Select lever in any other
than “2” rangeMore than 8
“1” range
switchB55 7Select lever in “1” range Less than 1
—
Select lever in any other
than “1” rangeMore than 8
Brake switch B55 12Brake pedal depressed More than 10.5
—
Brake pedal released Less than 1
Kick-down switch B55 11Throttle fully opened Less than 1
—
Throttle fully closed More than 6.5
AT OIL TEMP warning light B56 10Light ON Less than 1
—
Light OFF More than 9
Throttle position sensor B54 3Throttle fully closed 0.2 — 1.0
—
Throttle fully open 4.2 — 4.7
Throttle position sensor
power supplyB54 2Ignition switch ON (with
engine OFF)4.8 — 5.3 —
ATF temperature sensor B54 11ATF temperature 20°C
(68°F)1.6 — 2.0 2.1 k — 2.9 k
ATF temperature 80°C
(176°F)0.4 — 0.9 275 — 375
Rear vehicle speed sensor B55 24Vehicle stopped 0
450 — 650
Vehicle speed at least 20
km/h (12 MPH)More than 1 (AC range)
Front vehicle speed sensor B55 18Vehicle stopped 0
450 — 650
Vehicle speed at least 20
km/h (12 MPH)More than 1 (AC range)
Torque converter turbine
speed sensorB55 8Engine idling after warm-
up (D range)0
450 — 650
Engine idling after warm-
up (N range)More than 1 (AC range)
Vehicle speed output signal B56 17Vehicle speed at most 10
km/h (6 MPH)Less than 1 ←
→ More than 4—
Engine speed signal B55 17Ignition switch ON (with
engine OFF)More than 10.5
—
Ignition switch ON (with
engine ON)8 — 11
Cruise set signal B55 22When cruise control is set
(SET lamp ON)Less than 1
—
When cruise control is not
set (SET lamp OFF)More than 6.5
Torque control signal 1 B56 5Ignition switch ON (with
engine ON)More than 4 —
Torque control signal 2 B56 14Ignition switch ON (with
engine ON)More than 4 —
Torque control cut signal B55 10Ignition switch ON
(After engine is warmed-up)8—
Intake manifold pressure
signalB54 1 Engine idling after warm-up 0.4 — 1.6 —
Shift solenoid 1 B54 221st or 4th gear More than 9
10 — 16
2nd or 3rd gear Less than 1
Shift solenoid 2 B54 51st or 2nd gear More than 9
10 — 16
3rd or 4th gear Less than 1 Check with ignition switch ON.
ContentConnector
No.Terminal No. Measuring conditions Voltage (V)Resistance
to chassis
ground (Ω)

Load next 8 pages

Page: < prev 1-10 ... 2433-2440 2441-2448 2449-2456 2457-2464 2465-2472 2473-2480 2481-2488 2489-2496 2497-2504 ... 2872 next >

adblue reset climate control CD changer radiator cap fuel tank capacity transmission