2001 NISSAN ALMERA Service Manual

Page 1425 of 2898

NISSAN ALMERA 2001  Service Manual AEC110
DescriptionNJEC0654The vehicle speed sensor is installed in the transaxle. It contains a
pulse generator which provides a vehicle speed signal to the
speedometer. The speedometer then sends a s

Page 1426 of 2898

NISSAN ALMERA 2001  Service Manual exceed 10 km/h (6 MPH) when rotating wheels with suit-
able gear position.
4) If NG, go to ªDiagnostic Procedureº, EC-705.
WITHOUT CONSULT-IINJEC0657S021) Lift up the vehicle.
2) Start engine.
3) Re

Page 1427 of 2898

NISSAN ALMERA 2001  Service Manual Wiring DiagramNJEC0658SEDANNJEC0658S01
HEC882
DTC P0500 VEHICLE SPEED SENYD
Wiring Diagram
EC-703

Page 1428 of 2898

NISSAN ALMERA 2001  Service Manual HATCHBACKNJEC0658S02
NEF335A
DTC P0500 VEHICLE SPEED SENYD
Wiring Diagram (Contd)
EC-704

Page 1429 of 2898

NISSAN ALMERA 2001  Service Manual Diagnostic ProcedureNJEC0659
1 CHECK VEHICLE SPEED SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch ªOFFº.
2. Disconnect ECM harness connector and combination meter harness con

Page 1430 of 2898

NISSAN ALMERA 2001  Service Manual SEF893Y
DescriptionNJEC0738The stop lamp switch is installed to brake pedal bracket. The switch
senses brake pedal position and sends an ON-OFF signal to the
ECM. The ECM uses the signal to control th

Page 1431 of 2898

NISSAN ALMERA 2001  Service Manual 3) Turn ignition switch ªOFFº, wait at least 5 seconds and then
turn ªONº.
4) Perform ªDiagnostic Test Mode II (Self-diagnostic results)º with
ECM.
5) If DTC is detected, go to ªDiagnostic Proc

Page 1432 of 2898

NISSAN ALMERA 2001  Service Manual Wiring DiagramNJEC0742SEDAN MODELS AND HATCHBACK MODELS WITH ECM IN ENGINE COMPARTMENTNJEC0742S01
HEC887
DTC P0571 BRAKE SWYD
Wiring Diagram
EC-708