2001 NISSAN ALMERA Service Manual

Page 1057 of 2898

NISSAN ALMERA 2001  Service Manual 3 DETECT MALFUNCTIONING PART
Check the following.
+Joint connector-4 (If so equipped)
+Joint connector-6 (If so equipped)
+Harness connectors E75, F36 (If so equipped)
+Harness for open or short betwe

Page 1058 of 2898

NISSAN ALMERA 2001  Service Manual SEF121X
Component InspectionNJEC0557CRANKSHAFT POSITION SENSOR (POS)NJEC0557S011. Disconnect crankshaft position sensor (POS) harness connec-
tor.
2. Loosen the fixing bolt of the sensor.
3. Remove th

Page 1059 of 2898

NISSAN ALMERA 2001  Service Manual SEF058X
Component DescriptionNJEC0220The camshaft position sensor (PHASE) senses the protrusion pro-
vided with exhaust valve cam sprocket to identify a particular cyl-
inder. The crankshaft position

Page 1060 of 2898

NISSAN ALMERA 2001  Service Manual On Board Diagnosis LogicNJEC0222
DTC No. Malfunction is detected when ... Check Items (Possible Cause)
P0340
0340+The cylinder No. signal is not entered to ECM for the first
few seconds during engine

Page 1061 of 2898

NISSAN ALMERA 2001  Service Manual Wiring DiagramNJEC0224SEDAN MODELS AND HATCHBACK MODELS WITH
ECM IN ENGINE COMPARTMENT
NJEC0224S01
HEC793
DTC P0340 CAMSHAFT POSITION SENSOR (CMPS) (PHASE)QG
Wiring Diagram
EC-337

Page 1062 of 2898

NISSAN ALMERA 2001  Service Manual HATCHBACK MODELS WITH ECM IN CABINNJEC0224S02
HEC975
DTC P0340 CAMSHAFT POSITION SENSOR (CMPS) (PHASE)QG
Wiring Diagram (Contd)
EC-338

Page 1063 of 2898

NISSAN ALMERA 2001  Service Manual Diagnostic ProcedureNJEC0225
1 CHECK STARTING SYSTEM
Does the engine turn over?
(Does the starter motor operate?)
YesorNo
Ye s©GO TO 2.
No©Check starting system. (Refer to EL section.)
2 RETIGHTEN G

Page 1064 of 2898

NISSAN ALMERA 2001  Service Manual 3 CHECK POWER SUPPLY
1. Disconnect camshaft position sensor harness connector.
JEF114Y
2. Turn ignition switch ªONº.
3. Check voltage between terminal 3 and ground with CONSULT-II or tester.
SEF113Y