1991 LEXUS SC400 Service Repair Manual

4WDoilairbag disablesteering wheel adjustmentdimensionsoil type
Popular search:
ignitioncheck engineair filterautomatic transmission fluidopen hoodlow beamheight adjustment
Previous
Next
Load previous 8 pages

Page 377 of 4087

LEXUS SC400 1991 Service Repair Manual ON±VEHICLE REPAIR AT06Y±04 CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the ªLOCKº posi- tion and the negative (±) terminal cable is disconnected

Page 378 of 4087

LEXUS SC400 1991 Service Repair Manual 6. INSTALL EXTENSION HOUSING REAR OIL SEAL (a) Coat the lip of oil seal with MP grease. (b) Using SST and a hammer, drive in a new oil seal with the lipfacing downward. SST 09309±37010 Oil seal d

Page 379 of 4087

LEXUS SC400 1991 Service Repair Manual SPEED SENSOR NO.1 VEHICLE SPEED SENSOR REPLACEMENT (w/ Speedometer Driven Gear) AT070±04 1. REMOVE TRANSMISSION CONTROL ROD REAR SIDERemove the transmission control rod rear side set nut. 2. DISCON

Page 380 of 4087

LEXUS SC400 1991 Service Repair Manual NO.2 VEHICLE SPEED SENSOR REPLACEMENT AT0GF±02 1. DISCONNECT NO.2 VEHICLE SPEED SENSORCONNECTOR 2. REMOVE NO.2 VEHICLE SPEED SENSOR (a) Remove the bolt and No.2 vehicle speed sensor. (b) Remove t

Page 381 of 4087

LEXUS SC400 1991 Service Repair Manual PARK/NEUTRAL POSITION (PNP) SWITCH PARK/NEUTRAL POSITION SWITCH REPLACEMENT AT073±04 1. REMOVE FRONT EXHAUST PIPE(See pages EG±204) 2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR 3. REMOV

Page 382 of 4087

LEXUS SC400 1991 Service Repair Manual VALVE BODY VALVE BODY REMOVAL AT0GG±02 1. DRAIN ATF 2. REMOVE FRONT EXHAUST PIPE(See pages EG±204) 3. REMOVE OIL PAN (a) Remove the 19 bolts. (b) Install the blade of SST between the transmiss

Page 383 of 4087

LEXUS SC400 1991 Service Repair Manual 7. REMOVE 4 SOLENOID VALVES (a) Remove the No. 1 and No.2 solenoid valves. (b) Remove the O±rings from the No. 1 and No.2 solenoidvalves. (c) Remove the lock plate and No.3 and No.4 solenoid val

Page 384 of 4087

LEXUS SC400 1991 Service Repair Manual VALVE BODY INSTALLATION AT0GH±02 1. INSTALL 4 SOLENOID VALVES 2. INSTALL CHECK BALL BODY AND SPRING AND HOLDIT 3. INSTALL VALVE BODY (a) Align the groove of the manual valve to the pin of the lev
Load next 8 pages
Page:   < prev 1-10 ... 345-352 353-360 361-368 369-376 377-384 385-392 393-400 401-408 409-416 ... 4088 next >
climate controlwarning lightisofixtechnical databrake sensortrip computer
Popular search:
fuel pumptowingbrakesfuel capbolt patterndashboardodometer