2008 INFINITI FX35 Service Manual

child lock adblue reset catalytic converter fuses seat memory fuel filter location

Load previous 8 pages

Page 585 of 3924

INFINITI FX35 2008 Service Manual
AV-38
< SERVICE INFORMATION >
AUDIO
NO >> GO TO 2. (Without telephone system) GO TO 3. (With telephone system)
2.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect A/C and AV switch and spir

Page 586 of 3924

INFINITI FX35 2008 Service Manual
AUDIOAV-39
< SERVICE INFORMATION >
C
DE
F
G H
I
J
L
M A
B
AV
N
O P
2. Check continuity between spiral cable connector M15 terminals 24, 31, 32 and spiral cable connector M203 terminals 20, 17, 16.
O

Page 587 of 3924

INFINITI FX35 2008 Service Manual
AV-40
< SERVICE INFORMATION >
AUDIO
3. Check continuity between audio unit harness connector M59 ter-minal 12 and BOSE speaker amp. harness connector B213 ter-
minal 31.
4. Check continuity between a

Page 588 of 3924

INFINITI FX35 2008 Service Manual
AUDIOAV-41
< SERVICE INFORMATION >
C
DE
F
G H
I
J
L
M A
B
AV
N
O P
3. Check the signal between audio unit harness connector M60 terminal 22 and ground with CONSULT-III or oscilloscope.
OK or NG
OK >>

AUDIOAV-41
< SERVICE INFORMATION >
C
DE
F
G H
I
J
L
M A
B
AV
N
O P
3. Check the signal between audio unit harness connector M60 terminal 22 and ground with CONSULT-III or oscilloscope.
OK or NG
OK >> INSPECTION END (System is OK.)
NG >> Replace unified meter and A/C amp.
Locking CD Auto-Changer MechanismINFOID:0000000001328690
CAUTION:
Prior to removing a malfunctioning CD auto-changer unit that will be shipped for repair, the changer mechanism MUST BE LOCKED to prevent the mech anism from being damaged during shipping.
If a CD is jammed or unable to be removed from th e unit, do NOT lock the changer mechanism. If the
unit is to be shipped for repair, carefully package the unit to prevent vibration and shock.
DAMPER LOCK PROCEDURE
1. Eject and remove any CDs from the audio unit.
2. Turn ignition switch OFF. Wait until audio unit display is off and mechanism stops moving (mechanism
sound stops).
3. Press any one of the disc selection buttons once. When a display shows on the audio unit, press the
same disc selection button again within 5 seconds.
The changer mechanism will lock itself within 10 seconds.
4. After mechanism stops moving (mechanism s ound stops), open the driver and passenger window, and
then disconnect negative battery cable.
NOTE:
After installing a new or remanufactured audio unit, switching the audio unit ON will automatically unlock the
mechanism. A special unlocking procedure is not required.
Removal and Installation of Audio UnitINFOID:0000000001328691
REMOVAL
1. Perform damper lock operation. Refer to AV-41, "Locking CD Auto-Changer Mechanism".
2. Remove cluster lid C. Refer to IP-10
.
3. Remove screws (6) with power tool, and remove audio unit with display and unified meter and A/C amp. from instrument panel.
4. Remove screws and remove audio unit.
INSTALLATION
Te r m i n a l Condition Reference
signal
(+) (–)
22 Ground When vehicle speed is ap-
prox. 40 km/h (25 MPH)
SKIA6809E
ELF1080D
SKIA5800E
3AA93ABC3ACD3AC03ACA3AC03AC63AC53A913A773A893A873A873A8E3A773A983AC73AC93AC03AC3
3A893A873A873A8F3A773A9D3AAF3A8A3A8C3A863A9D3AAF3A8B3A8C

Page 589 of 3924

INFINITI FX35 2008 Service Manual
AV-42
< SERVICE INFORMATION >
AUDIO
Installation is the reverse order of removal.
Disassembly and Assembly of Audio UnitINFOID:0000000001328692
DISASSEMBLY
Remove audio unit screws (8) and display s

Page 590 of 3924

INFINITI FX35 2008 Service Manual
AUDIOAV-43
< SERVICE INFORMATION >
C
DE
F
G H
I
J
L
M A
B
AV
N
O P
Removal and Installation for Front Door SpeakerINFOID:0000000001328694
REMOVAL
1. Remove front door finisher. Refer to EI-36, "Comp

Page 591 of 3924

INFINITI FX35 2008 Service Manual
AV-44
< SERVICE INFORMATION >
AUDIO
Removal and Installation for Tweeter
INFOID:0000000001328697
REMOVAL
1. Remove rear pillar upper garnish assembly. Refer to EI-45, "Component Parts Location".
2.

Page 592 of 3924

INFINITI FX35 2008 Service Manual
AUDIOAV-45
< SERVICE INFORMATION >
C
DE
F
G H
I
J
L
M A
B
AV
N
O P
3. Remove nuts (2) with power tool, and remove assist bracket.
4. Remove nuts (4) with power tool, and remove bracket.
INSTALLATION

Load next 8 pages

Page: < prev 1-10 ... 553-560 561-568 569-576 577-584 585-592 593-600 601-608 609-616 617-624 ... 3928 next >

warning lights battery cabin filter tailgate gas mileage fuse box location