1998 JAGUAR X308 Workshop Manual

keycheck oilfuse boxbattery capacitybrakeradiator
Popular search:
Overflowsupercharger removalparking sensorsoverheatingdriveshaftoil filterparking brake ORDER BY 99
Previous
Next
Load previous 8 pages

Page 721 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16. Disconnect the coolant hoses from the throttle body. Release the clip which secures the coolant return hose and disconnect the hose. Fit a blanking plug to the hose to prevent water leak

Page 722 of 2490

JAGUAR X308 1998 2.G Workshop Manual 20. Release the induction elbow su pport; working from the right hand side. 1. Disconnect the vacuum pi pe from the centre of the induction elbow. 2. Remove the upper bolt from the induction e

Page 723 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 24. Disconnect the fuel return hose. 1. Disconnect the fuel retu rn hose at the Quick Fit connector, using special tool 310 - 054. 25. Remove the inlet manifold. 1. Remove the

Page 724 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Fit the inlet manifold to the engine. 1. Fit the inlet manifold. 2. Fit the ten bolts which secure the inlet manifold. 4. Connect the fuel feed hose. 1. Connect the fuel feed hose at the

Page 725 of 2490

JAGUAR X308 1998 2.G Workshop Manual 7. Refit the induction elbow support ; working from the left hand side. 1. Fit the upper bolt to the induction elbow support bracket. 2. Tighten the lower two bolts at the induction elbow su

Page 726 of 2490

JAGUAR X308 1998 2.G Workshop Manual 11. Reconnect the multi-plug, located on the bracket under the left side of th e throttle body. 12. Connect the coolant hoses to the throttle body. Remove the blanking plugs from the hoses

Page 727 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Connect the vacuum pipe elbow to the throttle actuator. 15. Fit the intake tube / air flow meter / air cleaner cover assembly. 1. Fit a new rubber seal; air in take tube to throttle body.

Page 728 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Reconnect the breather pipe to the stub pipe. 21. Carefully refit the engine covers, taking care not to damage the plastic fixings or the rubber inserts. 22. Connect the battery ground
Load next 8 pages
Page:   < prev 1-10 ... 689-696 697-704 705-712 713-720 721-728 729-736 737-744 745-752 753-760 ... 2496 next >
mileagefusessensorbonnetTPMStowing capacity
Popular search:
dead batteryfuel fill door releasecenter consolefour wheel driveCD changerelectricalcoil ignition