1998 JAGUAR X308 Workshop Manual

service interval resetaudioandroid autowipersoil dipstickfuel type
Popular search:
idler pulleyAirbag moduleV8 superchargedclockrun flatfuel injector removalbrakes
Previous
Next
Load previous 8 pages

Page 841 of 2490

JAGUAR X308 1998 2.G Workshop Manual 15. Release the air conditioning compressor. Remove the lower securing bolts. Loosen, but do not remove, th e upper securing bolts. Release the compressor from the lower dowel. 1

Page 842 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 19. Remove the eight screws an d release the windage tray. 20. Remove the oil filter adaptor. 21. Clean all components and releva nt mating faces; cylinder block, oil pan, oil

Page 843 of 2490

JAGUAR X308 1998 2.G Workshop Manual tighten to 5-7 Nm. 2. Install the oil filter adapto r and tighten to 26-34 Nm. 3. Apply a continuous bead of RTV sealant (Loctite 5699) 3 mm diameter, around the bed plate flange OR around t

Page 844 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Position and align the oil pan body to the bedplate. Install the sixteen bolts and tighten to 20-22 Nm in the sequence indicated. Confirm that the transmission face of the sump body

Page 845 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Install and tighten the bolts to 11-13 Nm. 7. Install the oil pan gasket to the oil pan body assembly. Insert the seal into the locating positions in the groove, working around from a co

Page 846 of 2490

JAGUAR X308 1998 2.G Workshop Manual Tighten the oil filter to 15-18 Nm. 12. Install the crankshaft position sensor. 1. Install the sensor to the flywheel housing and fit the securing bolt. Tighten to 8-12 Nm. 2. Install the

Page 847 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16. Install the front cr ossmember. Refer to Operation 76.10.05. 17. Position the generator cooling duct to the oil pan body and install the two bolts. 18. Install the undert ray. Refer to

Page 848 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Upper Oil Pan4.0L SC V8 - AJ26, 4.0L, Vehicles With: Supercharger In-vehicle Repair Removal Special Tool(s) Installer/remover, Oil Filter 303-752 1. Disconnect the batt ery ground
Load next 8 pages
Page:   < prev 1-10 ... 809-816 817-824 825-832 833-840 841-848 849-856 857-864 865-872 873-880 ... 2496 next >
steering wheelbrake padswheel torquemaintenance scheduleapple carplayfuse
Popular search:
handbraketransmission fluidrefilling coolantAir Vent Coverbrake pads replacementwidthdifferential