1998 JAGUAR X308 Workshop Manual

steering wheel adjustmentbuttonsbrake rotorservice resetcheck engine lightkey
Popular search:
Steering column boltsclimate controlrelaycoolant temperaturewindowoil pressuresteering control module
Previous
Next
Load previous 8 pages

Page 1537 of 2490

JAGUAR X308 1998 2.G Workshop Manual Measure the insulation resistance between sensor pin 001 and sensor body 1 Repeat for pin 003 and sensor body 2 Is the resistance > 10 MOHM? Yes GO to A9 No Renew the O2 sensor and reconnect p

Page 1538 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM010 and EM014 disconnected, measure the resistance between EM010/023 and chassis ground EM008L. 1 Is the resistance < 0.5 OHM? Yes GO to A10 No Inspect connector EM010 for co rrosion, da

Page 1539 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM010 and EM014 disconnected, measure the resistance between EM014/004 and chassis ground EM008L. 1 Is the resistance < 0.5 OHM? Yes GO to A12 No Inspect connector EM014 for co rrosion, da

Page 1540 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM021 disconnected, measure the resistance between EM012/015 and EM021/003 1 Is the resistance < 0.5 OHM? Yes GO to A13 No Inspect harness / connecto rs EM012, and EM021 for cor

Page 1541 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM021 disconnected, measure the resistance between EM012/022 and EM021/004 1 Is the resistance < 0.5 OHM? Yes GO to A14 No Inspect harness / connectors EM012, EM021 and splice

Page 1542 of 2490

JAGUAR X308 1998 2.G Workshop Manual Ignition switch to position 0 1 Disconnect EM010 and EM012 Inside ECM housing 2 Ignition switch to position II 3 Measure the voltage between EM010/023 and EM012/015 4 Is the voltage 0 (zero

Page 1543 of 2490

JAGUAR X308 1998 2.G Workshop Manual Is the voltage 0 (zero) V? Yes GO to A16 No Inspect harness / connectors EM010, EM012, and EM021 for corrosion, damaged / pushed back pins. Repair as necessary and reconnect plug(s). GO to A1

Page 1544 of 2490

JAGUAR X308 1998 2.G Workshop Manual Ignition switch to position 0 1 Remove EMS fuse F14 2 Disconnect EM010 and EM015 Inside ECM housing 3 Using a link lead, bridge EM010/016 and EM010/022 4 Ignition switch to position II 5 Me
Load next 8 pages
Page:   < prev 1-10 ... 1505-1512 1513-1520 1521-1528 1529-1536 1537-1544 1545-1552 1553-1560 1561-1568 1569-1576 ... 2496 next >
rear view mirroralarmdoor locklanguagedrain boltignition
Popular search:
oil levelFront absorbercrankshaft position sensor testchargerfuse diagramV8 superchargedspeed control