1998 JAGUAR X308 Workshop Manual

battery capacityset clockair suspensionbatterykeyless entryphone
Popular search:
tire sizebattery chargerFront bumperFront crossmemberfuel injector connectorRadio coderemove oxygen sensor
Previous
Next
Load previous 8 pages

Page 833 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 19. Remove the eight screws an d release the windage tray. 20. Remove the oil filter adaptor. 21. Clean all components and releva nt mating faces; cylinder block, oil pan, oil

Page 834 of 2490

JAGUAR X308 1998 2.G Workshop Manual tighten to 5-7 Nm. 2. Install the oil filter adapto r and tighten to 26-34 Nm. 3. Apply a continuous bead of RTV sealant (Loctite 5699) 3 mm diameter, around the bed plate flange OR around t

Page 835 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Position and align the oil pan body to the bedplate. Install the sixteen bolts and tighten to 20-22 Nm in the sequence indicated. 6. Install the oil pick-up pipe. 1. Install a new O-r

Page 836 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Install and tighten the bolts to 11-13 Nm. 7. Install the oil pan gasket to the oil pan body assembly. Insert the seal into the locating positions in the groove, working around from a co

Page 837 of 2490

JAGUAR X308 1998 2.G Workshop Manual Tighten the oil filter to 15-18 Nm. 12. Install the crankshaft position sensor. 1. Install the sensor to the flywheel housing and fit the securing bolt. Tighten to 8-12 Nm. 2. Install the

Page 838 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16. Install the front cr ossmember. Refer to Operation 76.10.05. 17. Position the generator cooling duct to the oil pan body and install the two bolts. 18. Install the undert ray. Refer to

Page 839 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Upper Oil Pan4.0L NA V8 - AJ27, 4.0L In-vehicle Repair Removal Special Tool(s) Installer/remover, Oil Filter 303-752 1. Disconnect the batt ery ground cable. Remove the battery c

Page 840 of 2490

JAGUAR X308 1998 2.G Workshop Manual Wipe the drain plug and install it to the oil pan to prevent oil dripping. Move the oil bowser away from the vehicle. 10. Remove the oil pan. 1. Remove the eighteen bolt s which secur
Load next 8 pages
Page:   < prev 1-10 ... 801-808 809-816 817-824 825-832 833-840 841-848 849-856 857-864 865-872 ... 2496 next >
brake sensortiming beltCD playercompression ratiodriver seat adjustmentflat tire
Popular search:
fuse box locationgas typeheatingSunroofElectronic engine controlsservice interval resetfuel cap