1998 JAGUAR X308 Workshop Manual

catalytic converterwindowwinter tyrespower steering fluidair filteroil reset
Popular search:
rear entertainmentAdaptiveMass air flowclock settingcoolant temperaturelowerBelt idler
Previous
Next
Load previous 8 pages

Page 953 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Cooling System Draining, Filling and Bleeding4.0L NA V8 - AJ27/3.2L NA V8 - AJ26 Gen eral Procedures Drain Refill 1. O pen the engine compartment and fit paintwork protectio

Page 954 of 2490

JAGUAR X308 1998 2.G Workshop Manual Allow at least 2 minutes f or ai r to purge from the system. Top up the he ader tank as re quired and fit the pressure cap. 2. Switch on the ignition, switch off the climate control

Page 955 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Cooling System Draining, Filling and Bleeding4.0L SC V8 - AJ26 Gen eral Procedures Drain Refill 1. O pen the engine compartment and fit paintwork protection sheets. 2. En

Page 956 of 2490

JAGUAR X308 1998 2.G Workshop Manual • NOTE : To ensure that air is not drawn into the system during the following operations: Do not remove the cap from the header tank whilst the charge air cooling system is open to atmosphe

Page 957 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. R un the engine at between 1500 and 2000 rpm until the cooling fans operate. 10. Switch on the climate control system, set to maximum heat, and check that heat is coming from the heater

Page 958 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Cooling System Draining and Vacuum Filling Gene ral Procedures WARNING: To avoid having scalding ho t coolant or steam blowing out of the cooling system, use extreme care when rem

Page 959 of 2490

JAGUAR X308 1998 2.G Workshop Manual R emove the drain tray. 6. Lower the vehicle. 7. Inst all the cooling system va cuum refill adaptor to the expansion tank. 8. Inst all the vacuum filler gauge to the cooling system

Page 960 of 2490

JAGUAR X308 1998 2.G Workshop Manual 11. P osition the evacuated air hose into a container. 12 . N OTE: Make sure the coolant su pply valve is in the closed position on the vacuum filler gauge assembly. • NOTE: The coolant va
Load next 8 pages
Page:   < prev 1-10 ... 921-928 929-936 937-944 945-952 953-960 961-968 969-976 977-984 985-992 ... 2496 next >
jump startcatalytic converterstart stop buttonheadrestjump start terminalstransmission
Popular search:
Brake light fusehood open76.22.78fuel filter86.60.01automatic transmission fluidinjector