Page 209 of 2490
Remove brackets.
4
. Remove stabilizer bar from vehicle.
Remove bushes.
5. Clean relevant parts.
Installation
1
.
C
AUTION:
Make sure the Castrol NTRgrease is only applied to the inner surface of the mounting bushes.
Failure to follow this instruction may affect the retention of the bushes in the retaining brackets.
Fit bushes to stabilizer bar. Apply a thin film of Castrol NTR grease to the inner surface of the bushes.
Page 210 of 2490
2.
Position stabilizer bar to vehicle.
Position stabilizer bar to links.
Fit nuts and bolts, DO NOT tighten at this stage.
3.
Fit mounting brackets to stabilizer bar.
Align bushes and fit mounting brackets.
Fit and tighten bolts.
Page 211 of 2490
4
. Tighten nuts securing stabilizer bar to links.
5. Lower four-post lift.
Page 212 of 2490
In
stallation
1.
Posi ti
on monostrut on rear suspension.
2. Align m o
nostrut upper mountings and install but do not tighten
bolts
3. Ra
ise rear of suspension to
align with monostrut lower
mounting holes.
4. Inst al
l monostrut lower bolts and nuts and tighten to 77-103
Nm.
5. Tighten monostrut upper bolts to 88-118 Nm.
Page 213 of 2490
6.
R
aise vehicle, remove stands
and lower vehicle. Refer to
Section 100-02.
Page 214 of 2490
St
abilizer Bar Bushing Vehicles With: Supercharger
64.35.18
Rubber Suspension Insulator Lube
Castrol NTR
Removal
1.
CA
UTION:
Replacement of nuts and bolts: Various thread-locking devices are used on nuts and bolts
throughout the vehicle. These devices restrict the number of times a nut or bolt can be used. See
section <<100-00>>
for information.
Raise vehicle on a four-post lift. Refer to section <<100-02>>.
2.
Remove nuts and bolts securing stabilizer bar to links.
3.
Remove stabilizer bar mounting-brackets.
Remove bolts.
Page 215 of 2490
Remove brackets.
4
. Remove stabilizer bar from vehicle.
Remove bushes.
5. Clean relevant parts.
Installation
1
.
C
AUTION:
Make sure the Castrol NTR grease is only applied to the inner surface of the mounting bushes.
Failure to follow this instruction may affect the retention of the bushes in the retaining brackets.
Fit bushes to stabilizer bar. Apply a thin film of Castro NTR grease to the inner surface of the bushes.
Page 216 of 2490
2.
Position stabilizer bar to vehicle.
Position stabilizer bar to links.
Fit nuts and bolts, DO NOT tighten at this stage.
3.
Fit mounting brackets to stabilizer bar.
Align bushes and fit mounting brackets.
Fit and tighten bolts.