1998 JAGUAR X308 Workshop Manual

remove seatshandbrakefuse diagramcoolantbattery replacementkey
Popular search:
rear entertainmentfault code303-13spare wheelsupercharger removalWipesoxygen
Previous
Next
Load previous 8 pages

Page 673 of 2490

JAGUAR X308 1998 2.G Workshop Manual 6. Rotate the crankshaft until the triangular arrow indent on the drive plate is visible thro ugh the access hole; confirm that the timing flat on ea ch camshaft is uppermost. 7. Install the cr

Page 674 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 12. Remove the bolt which secures the sprocket to the exhaust camshaft. Move the sprocket forward from the camshaft boss. 13. Remove the secondary chain tensioner. The tens

Page 675 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. With the wire in position, press the piston fully into the tensioner body. Remove the wire. 3. Install the chain tensioner between the chain path. 1. Reposition the sprocket, still capt

Page 676 of 2490

JAGUAR X308 1998 2.G Workshop Manual 11. Install the crankshaft position sensor. 1. Install the sensor to the flywheel housing and fit the securing bolt. Tighten to 8-12 Nm. 2. Install the access grommet to the housing. 12. L

Page 677 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Exhaust Camshaft Sprocket RH4.0L SC V8 - AJ26/3.2L NA V8 - AJ26 In-vehicle Repair Removal Special Tool(s) Camshaft setting 303-530 Crankshaft setting 303-531 Timing chain tensio

Page 678 of 2490

JAGUAR X308 1998 2.G Workshop Manual 6. Rotate the crankshaft until the triangular arrow indent on the drive plate is visible thro ugh the access hole; confirm that the timing flat on ea ch camshaft is uppermost. 7. Install the

Page 679 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation removing the bolt which secures the sprocket. 1. Place a flat piece of stee l strip along the timing cover horizontal jointing face, adjacent to the exhaust camshaft sprocket. 2. S

Page 680 of 2490

JAGUAR X308 1998 2.G Workshop Manual allow the chain tensioning tool 303-532 to be approximately vertical, as shown. Remove the chain tensioni ng tool; during future operations, do not move the sprocket within the chain. 2. P
Load next 8 pages
Page:   < prev 1-10 ... 641-648 649-656 657-664 665-672 673-680 681-688 689-696 697-704 705-712 ... 2496 next >
wheelbasebatteryfuse boxbeltseat adjustmenttorque
Popular search:
end floatopen bonnetgearboxfuel injectionradio aerial76.46.03check engine light