1998 JAGUAR X308 Workshop Manual

infotainmentmirror controlsmaintenance schedulefusegas typechecking oil
Popular search:
battery locationAUTOMATICfault codeP1797aerialAir Vent Coverfold seats
Previous
Next
Load previous 8 pages

Page 1609 of 2490

JAGUAR X308 1998 2.G Workshop Manual Pinpoint test G: P0157, P0158 With EM010 and EM015 disconnected, measure the voltage between EM010/023 and EM015/002. 1 Is the voltage B+? Yes Remove link lead and reconnect all connectors. GO t

Page 1610 of 2490

JAGUAR X308 1998 2.G Workshop Manual Connect the scan tool 1 Have the DTC(s) and freeze frame data been recorded? Yes GO to G2 G2: CHECK FOR O2 SENSOR FAILURE Run the engine for a period to warm the sensor and then maintain a st

Page 1611 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as G2, suddenly decelerate to idle. 1 Has the voltage dropped to 400mV or less ? Yes GO to G4 No Renew O2 sensor and reconnect plug(s). GO to G6 G4: CHECK FOR O2 SENS

Page 1612 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as G3, suddenly accelerate to approximately 2500 rpm. 1 Has the voltage risen to between 600mV and 1 volt? Yes GO to G5 No Renew O2 sensor and reconnect plug(s). GO to

Page 1613 of 2490

JAGUAR X308 1998 2.G Workshop Manual With the conditions held as in G4, run the engine at 1500 rpm for approximately 3 minutes. 1 Does the displayed voltage drop below 400mV and rise above 500 mV, cycling approximately every 180 seco

Page 1614 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM024 disconnected, measure the resistance between EM012/016 and EM024/002. 1 Is the resistance < 0.5 OHM? Yes GO to G8 No Inspect harness / connecto rs EM012, and EM024 for cor

Page 1615 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM012 and EM024 disconnected, measure the resistance between EM012/022 and EM024/001. 1 Is the resistance < 0.5 OHM? Yes GO to G9 No Inspect harness / connecto rs EM012, and EM024 for cor

Page 1616 of 2490

JAGUAR X308 1998 2.G Workshop Manual With EM024 disconnected measure the insulation resistance between sensor pin 001 and sensor body. 1 Repeat for pin 002 and sensor body. 2 Is the resistance > 10 MOHM? Yes GO to G11 No Renew t
Load next 8 pages
Page:   < prev 1-10 ... 1577-1584 1585-1592 1593-1600 1601-1608 1609-1616 1617-1624 1625-1632 1633-1640 1641-1648 ... 2496 next >
mirror controlsheadlightswheel sizebattery capacitycheck engine lightchange time
Popular search:
p0335Rear brake light fusegearboxemergency towingPowerwashlow beamrear view mirror