1998 JAGUAR X308 Workshop Manual

set clockauxiliary battery locationengine oil capacityground clearancegearboxpark assist
Popular search:
clock resetradiator capfuel cap releasefront wheel bearinghood openfuel injection and supplytechnical specifications
Previous
Next
Load previous 8 pages

Page 2433 of 2490

JAGUAR X308 1998 2.G Workshop Manual 17. From engine compartment, install crossbeam front LH bolts and tighten to 22-28Nm.. 18. Install power steering fluid reservoir. Position reservoir on mounting bracket. Install re

Page 2434 of 2490

JAGUAR X308 1998 2.G Workshop Manual Repeat procedure to install opposite side shock absorber. 21. Install lower steering column on pinion shaft. Move column downwards to engage coupling splines on pinion shaft. 1. Instal

Page 2435 of 2490

JAGUAR X308 1998 2.G Workshop Manual 26. Install power steering pi pes on pinion housing. Remove blanks and install new O-ring seals in pipe connectors. Apply power steering fluid to O ring seals. Remove blanking p

Page 2436 of 2490

JAGUAR X308 1998 2.G Workshop Manual 30. Connect steering harness. Route harness connector to body front location. Connect steering ha rness connector. Install connector in body retaining clip. 31. Connect wheel spe

Page 2437 of 2490

JAGUAR X308 1998 2.G Workshop Manual 35. Using new tiestrap, secure undertray to crossbeam brace. 36. Install generator cool ing duct deflector. Position deflector over rear vertical duct. Slide deflector forward to eng

Page 2438 of 2490

JAGUAR X308 1998 2.G Workshop Manual 41. Ensuring graduation mark remains aligned, finally tighten wishbone front eccentric bolt to 113-153Nm. 42. Install air intake tube/meter/ cleaner cover assembly. Refer to 19.10.30 43

Page 2439 of 2490

JAGUAR X308 1998 2.G Workshop Manual Uni-Body, Subframe and Mounting System - Front Axle Crossmember Front Bushing Removal and Installation Removal CAUTION: Replacement of nuts and bolts: Various thread-locking devices are used on n

Page 2440 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. Raise front of vehicle. 10. Remove generator cool ing duct deflector. Remove bolt. Move deflector rearwards to release tangs from undertray. Release deflector from rear vertical
Load next 8 pages
Page:   < prev 1-10 ... 2401-2408 2409-2416 2417-2424 2425-2432 2433-2440 2441-2448 2449-2456 2457-2464 2465-2472 ... 2496 next >
climate settingsbolt patternlane assistauxiliary battery locationwipersapple carplay
Popular search:
fuel pumpbrakeAUTOMATIChigh beamrear view mirroroil dipstickrefuelling