1998 JAGUAR X308 Workshop Manual

jacking pointstransmission oiloil pressurechargingdoor lockfuel consumption
Popular search:
wheel alignmentcruise control lampbattery chargercompression ratiopulleytiming beltrear electric seats
Previous
Next
Load previous 8 pages

Page 961 of 2490

JAGUAR X308 1998 2.G Workshop Manual Vehic les with supercharger 16 . Allow one minute to check the vacuum is held. Di sconnect the air supply. 17 . NOTE: Close the coolant supply valve when the coolant expansion tank

Page 962 of 2490

JAGUAR X308 1998 2.G Workshop Manual All vehicles 21. N OTE: Install a new sealing washer. • NOTE: Clean off any spillages. Install the supercharger coolant fill plug. Tighte n to 45 Nm. 22. Remove the coolant expan

Page 963 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Coolant Expansi on Tank Re moval and Installation Remov al 1. O pen the engine compartment and fit paintwork protection sheets. 2. R emove the centre trim panel from the

Page 964 of 2490

JAGUAR X308 1998 2.G Workshop Manual In stallation re move it from the vehicle. 9. Empty any surplus coolant from the expansion tank into a drain tray. 10. Remove the cloth from the engine and clean any spillage from the

Page 965 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Coolant Outlet Pipe Re moval and Installation Remov al Installation 1. O pen the engine compartment and fit paintwork protection sheets. 2. Drain the radiator. Refer t

Page 966 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Coolant Outlet Pipe Remo val and Installation Remov a l 1. Op en the engine compartment and fit paintwork protection sheets. 2. Drain the radiator. Refer to Ge neral Procedu

Page 967 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 8. Remove an d discard the sealing rings from the outlet pipe grooves. 1. Installation is th e reverse of the re moval procedure. Use new sealing rings on th e coolant

Page 968 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine Cooling - Cooling Fan Motor Remo val and Installation Remov a l Installation 1. Re move the Twin Fan and Motor Assembly (26.25.12) described in this section. 2. Re move the fa
Load next 8 pages
Page:   < prev 1-10 ... 929-936 937-944 945-952 953-960 961-968 969-976 977-984 985-992 993-1000 ... 2496 next >
auxiliary batteryengine coolantsensordashboardfour wheel driveload capacity
Popular search:
Steering column boltsHeater hosepedalservice apichainengine ignitionroof rack