1998 JAGUAR X308 Workshop Manual

jump startsuspensionheight adjustmentautomatic transmission fluidradio controlsnavigation system
Popular search:
interior lightsvacuumRecommended půlcrankshaft position sensorRadio codewater pumpDoor remove
Previous
Next
Load previous 8 pages

Page 1809 of 2490

JAGUAR X308 1998 2.G Workshop Manual 10. Disconnect radiator bottom hose. 1. Release hose retaining clip. 2. Disconnect hose. 11. Disconnect radiator top hose. 1. Release hose retaining clip. 2. Disconnect hose. 12. Disconn

Page 1810 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. Disconnect compressor to condenser discharge line from condenser. 1. Remove bolt. 2. Discard O-ring seal. 3. Install suitable blanking plugs. 15. Disconnect condenser to receiver / dri

Page 1811 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 18. Remove radiator / condenser assembly. Clean coolant spillage from radiator lower carrier panel. 19. Separate condenser from radiator. 1. Remove bolts. 2. Remove conden

Page 1812 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. If previously removed, install condenser to receiver / drier line at condenser. Remove blanking plugs. Install new O-ring seal and lubricate with clean compressor oil. Install

Page 1813 of 2490

JAGUAR X308 1998 2.G Workshop Manual Connect hose. Install bolt (8-10 Nm). 6. Connect compressor to condenser discharge line at condenser. Remove blanking plugs. Install new O-ring seal an d lubricate with clean A/

Page 1814 of 2490

JAGUAR X308 1998 2.G Workshop Manual 10. Connect radiator top hose to radiator. 1. Connect top hose. 2. Reposition and tighten hose clip. 11. Install radiator retaining panel. Install bolts and sequenti ally tighten from ce

Page 1815 of 2490

JAGUAR X308 1998 2.G Workshop Manual 15. Remove the temporary wooden support strut and reconnect gas struts to the hood. 16. Check transmission fluid level an d top up as required; refer to 307A-01 (N/A) or 307B-01 (S/C), oper

Page 1816 of 2490

JAGUAR X308 1998 2.G Workshop Manual Air Conditioning - Evaporator Core Removal and Installation Removal 1. Remove heater / cooler unit; refer to 82.25.21. 2. Remove air conditioning control module from heater / cooler unit. 
Load next 8 pages
Page:   < prev 1-10 ... 1777-1784 1785-1792 1793-1800 1801-1808 1809-1816 1817-1824 1825-1832 1833-1840 1841-1848 ... 2496 next >
roof rackAUXturn signal bulbtransmission oilrear entertainmenttraction control
Popular search:
battery chargerfuel injector removalremote controlwheel alignmentSuspension faultTrip Computer211-02