1998 JAGUAR X308 Workshop Manual

towing capacityresetrecommended oilengine overheatoil dipsticksat nav
Popular search:
inflation pressuretire typerear view mirrorHead gasketbrake vacuum hoseclock settingtransmission oil
Previous
Next
Load previous 8 pages

Page 1449 of 2490

JAGUAR X308 1998 2.G Workshop Manual 8. Remove the centre trim panel from the engine compartment. 1. Remove the left hand side enclosure panel. 2. Remove the centre trim panel. 9. Move the coolant header tank for access. 1. D

Page 1450 of 2490

JAGUAR X308 1998 2.G Workshop Manual brackets. 3. Tighten the support hook adjusters to take the weight of the engine. 12. Raise the vehicle for access. 13. Remove the LH downpipe catalytic converter. Refer to Operation 17.50.09.

Page 1451 of 2490

JAGUAR X308 1998 2.G Workshop Manual 20. Lower the transmission unit. 21. Detach the gear selector cable from the transmission unit. 1. Remove the selector cable ball pin to selector lever nut. 2. Lower the transmissi on lift fo

Page 1452 of 2490

JAGUAR X308 1998 2.G Workshop Manual Discard the Dowty seals. Fit blanking plugs to the pipe and transmission. 24. Disconnect the fluid cooler lower pipe. Remove the banjo bolt. Discard the Dowty seals. Fit

Page 1453 of 2490

JAGUAR X308 1998 2.G Workshop Manual 29. NOTE: Viewed from the rear of the vehicle. Remove the two bolts which se cure the starter motor power cable clip. 30. NOTE: Viewed from the rear of the vehicle. Remove the ground lead b

Page 1454 of 2490

JAGUAR X308 1998 2.G Workshop Manual 34. NOTE: Do not allow the converter to detach from the transmission. Remove the transmission / converter assembly from the vehicle. Lower the lift and remove the transmission, ensuring th

Page 1455 of 2490

JAGUAR X308 1998 2.G Workshop Manual 38. Remove the harness link lead. 1. If required, slacken the harness heatshield spring clamp bolt. 2. Remove the heatshield lower bolt. 3. Release the harness multi- lock lever, disconne

Page 1456 of 2490

JAGUAR X308 1998 2.G Workshop Manual Automatic Transmission/Transaxle - 4.0L SC V8 - AJ26 - Input Shaft Seal Disassembly and Assembly of Subassemblies Special Tool(s) Oil seal replacer 307-378 1. Disconnect the battery ground l
Load next 8 pages
Page:   < prev 1-10 ... 1417-1424 1425-1432 1433-1440 1441-1448 1449-1456 1457-1464 1465-1472 1473-1480 1481-1488 ... 2496 next >
child seatcoolinglengthmaintenance resettireshigh beam
Popular search:
battery charger12.65.63instrument panelignitionglove boxweightp0420