1998 JAGUAR X308 Workshop Manual

power steeringAUXmanual radio setlow oil pressurepark assistESP inoperative
Popular search:
parking brake ORDER BY 1air conditioningservice apiautomatic gearwiper sizecruise control lampengine oil
Previous
Next
Load previous 8 pages

Page 873 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 8. Clean all relevant parts and mating faces. 1. Fit the new main seals to the cam cover. 1. Fit the new outer seal. 2. Fit the two new spark plug aperture seals. 2. Fit the se

Page 874 of 2490

JAGUAR X308 1998 2.G Workshop Manual securing screw. 5. Tighten the securing screws to 9-11 Nm. Tighten in the sequence indicated. 6. Reposition the clips which secure the engine harness to the cam cover. 7. Refit the on

Page 875 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Valve Springs LH In-vehicle Repair Removal Special Tool(s) Valve spring compressor 303-252 1. Open the engine compartment and fit paintwork protection sheets. 2. Set the engine compa

Page 876 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 9. Repeat the instructions for each valve spring to be removed. 10. Clean all relevant components. 1. Fit the valve spring. 1. Fit the valve spring. 2. Locate the valve collar o

Page 877 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Valve Springs RH In-vehicle Repair Removal Special Tool(s) Valve spring compressor 303-252 1. Open the engine compartment and fit paintwork protection sheets. 2. Set the engine compa

Page 878 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 9. Repeat the instructions for each valve spring to be removed. 10. Clean all relevant components. 1. Fit the valve spring. 1. Fit the valve spring. 2. Locate the valve collar o

Page 879 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Variable Camshaft Timing Oil Control Unit LH In-vehicle Repair Removal Special Tool(s) Camshaft setting 303-530 Timing chain tensioning 303-532 Wedges, primary chain 303-533

Page 880 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1. Remove the bolt which secures the crankshaft position sensor to the flywheel housing. Remove the sensor and allow it to hang free under the engine. 2. Remove the access grommet (for torqu
Load next 8 pages
Page:   < prev 1-10 ... 841-848 849-856 857-864 865-872 873-880 881-888 889-896 897-904 905-912 ... 2496 next >
auxiliary battery locationwheelhomelinkdeactivate airbagcruise controlservice interval
Popular search:
regulator torquetire pressurecruise controlHeater Hose JunctionPas pumpcheck oilFRONT DOOR