1998 JAGUAR X308 Workshop Manual

bulbnavigation systemcoolingtowingengine oildashboard warning lights
Popular search:
idle air control valveCD playerRadiator fan temp sensorcoolant reservoirwiringparking sensorswater pump
Previous
Next
Load previous 8 pages

Page 2185 of 2490

JAGUAR X308 1998 2.G Workshop Manual Glass, Frames and Mechanisms - Front Door Window Glass Weatherstrip Removal and Installation Removal Installation 1. Pull seal out of door frame channelling and discard seal. 2. Clean chan

Page 2186 of 2490

JAGUAR X308 1998 2.G Workshop Manual Glass, Frames and Mechanisms - Front Door Window Regulator and Motor Removal and Installation Removal 1. Ensure that door glass is in fully up position. 2. Remove battery cover and disc onnect g

Page 2187 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 1. Position motor/regulator assembly in door and fit onto glass. 2. Align motor with door holes and fit and tighten securing screws and nuts. 3. Position glass lift guide and fi

Page 2188 of 2490

JAGUAR X308 1998 2.G Workshop Manual supply from motor multiplug. 15. Adjust regulator up stop. Slacken stop securing bolt. Move stop rearwards to abut regulator quadrant. Tighten stop securing bolt. 16. Reconnect

Page 2189 of 2490

JAGUAR X308 1998 2.G Workshop Manual Glass, Frames and Mechanisms - Front Door Window Regulator Motor Removal and Installation Removal Installation 1. Remove lift motor and regulator assembly from door. Refer to 86.25.04. 2

Page 2190 of 2490

JAGUAR X308 1998 2.G Workshop Manual Glass, Frames and Mechanisms - Front Door Window Control Switch Removal and Installation Removal Installation 1. Remove casing/armrest asse mbly from door. Refer to 76.34.01. 2. Slacken

Page 2191 of 2490

JAGUAR X308 1998 2.G Workshop Manual Glass, Frames and Mechanisms - Rear Door Window Glass Removal and Installation Removal 1. Remove battery cover and disc onnect ground cable from battery terminal. Refer to 86.15.19. 2. Remove do

Page 2192 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 13. Withdraw glass upwards through aperture and out via outboard side of frame. 1. Position glass in aperture. 2. Locate leading edge of glass in seal of front channel. 3.
Load next 8 pages
Page:   < prev 1-10 ... 2153-2160 2161-2168 2169-2176 2177-2184 2185-2192 2193-2200 2201-2208 2209-2216 2217-2224 ... 2496 next >
fuel filter locationESPremote startaudioESP inoperativedead battery open trunk
Popular search:
coolant temperatureheatingFront crossmemberwiringtransmission oilcooling systemrear pads