1998 JAGUAR X308 Workshop Manual

fuel typedeactivate passenger airbagABSremote startradio antennapower steering
Popular search:
76.73.39center consolesport modechange timeheight adjustmentoverheatingautomatic transmission
Previous
Next
Load previous 8 pages

Page 2481 of 2490

JAGUAR X308 1998 2.G Workshop Manual Uni-Body, Subframe and Mounting System - Rear Axle Crossmember Removal and Installation Removal CAUTION: Replacement of nuts and bolts: Various thread-locking devices are used on nuts and bolts thr

Page 2482 of 2490

JAGUAR X308 1998 2.G Workshop Manual 6. Remove both mounting brac kets from the suspension subframe. 1. Remove bush center bolt from bracket. 2. Remove bolts securi ng bracket to body. Remove bracket. Following the same

Page 2483 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 11. Remove subframe from vehicle. 12. Clean relevant components and mating faces. 1. With assistance fit suspension subframe to vehicle. Position subframe on vehi cle, ensurin

Page 2484 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Tighten link assembly bolts to 88-118Nm. 6. Tighten subframe front to differential bracket nuts and bolts to 69-92Nm. 7. Where fitted, install fuel vapo r pipe to subframe bolts. 8. T

Page 2485 of 2490

JAGUAR X308 1998 2.G Workshop Manual 9. Position spacer in the rece ss of each subframe bush. 10. Raise jack to locate subframe bushes on the body tapered locations. 11. CAUTION: When installing su bframe bracket ensure that

Page 2486 of 2490

JAGUAR X308 1998 2.G Workshop Manual 13. Tighten mounting bracket bush center bolt to 80-100Nm. Following same procedure, tighten mounting bracket bush center bolt on opposite side. 14. Lower and remove jack. 15. Lower

Page 2487 of 2490

JAGUAR X308 1998 2.G Workshop Manual Uni-Body, Subframe and Mounting System - Rear Axle Crossmember Bushing Removal and Installation Removal CAUTION: Replacement of nuts and bolts: Various thread-locking devices are used on nuts and

Page 2488 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 5. CAUTION: Ensure special tool 204-116-06 is correctly aligned and does not contact the bush housing bore. Remove bush from subframe. 1. Align the top of special tool 204-116-06
Load next 8 pages
Page:   < prev 1-10 ... 2449-2456 2457-2464 2465-2472 2473-2480 2481-2488 2489-2496 next >
pairing phoneresetwarning lightrun flatAUXbattery capacity
Popular search:
oil temperatureparking brake ORDER BY 5076.73.37Suspensioninflation pressureheatingEngine general