1998 JAGUAR X308 Workshop Manual

fog lightABSroof rackservicetechnical specificationscoolant reservoir
Popular search:
snow chainsparking brake ORDER BY 80chargingfog lightalternator beltchange timeengine ignition
Previous
Next
Load previous 8 pages

Page 681 of 2490

JAGUAR X308 1998 2.G Workshop Manual Whilst applying the opposing force to the sprocket and chain, tighten the sprocket securing bolt to 115-125 Nm. Remove the chain tensioning tool. 6. Remove the tape and steel stri p

Page 682 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Exhaust Manifold LH In-vehicle Repair Removal Installation 1. Open the engine compartment and fit paintwork protection sheets. 2. Remove the front silencer. Refer to Section 309-00

Page 683 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Exhaust Manifold RH In-vehicle Repair Removal 1. Open the engine compartment and fit paintwork protection sheets. 2. Remove the air cleaner assemb ly. Refer to Section 303-12. 3. Remo

Page 684 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 9. Remove the manifold. 1. Remove the manifold and the manifold gasket from the cylinder head. 2. Remove the gasket from the EGR flange. 10. If fitting a new manifold, remove th

Page 685 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Tighten the rack mounting bolts on the drivers side. 6. From above the vehicle, connect the EGR pipe to the exhaust manifold. 1. Fit a new EGR gasket to the manifold. 2. Reposition the

Page 686 of 2490

JAGUAR X308 1998 2.G Workshop Manual Engine - Exhaust Manifold LH and RH In-vehicle Repair Removal 1. Open the engine compartment and fit paintwork protection sheets. 2. Remove the downpipe catalytic converter, right hand side. Re

Page 687 of 2490

JAGUAR X308 1998 2.G Workshop Manual 10. Remove the bolts which secure the front section of the right hand exhaust manifold to the cylinder head. 11. Working from below the vehicle, remove the manifold bolts. 1. Remove the bo

Page 688 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 1. Use new manifold securing bolt s and.fit a spacer to each. 2. Fit each manifold and manifold gasket. 1. Fit and align the new gasket to the cylinder head. 2. Fit and align th
Load next 8 pages
Page:   < prev 1-10 ... 649-656 657-664 665-672 673-680 681-688 689-696 697-704 705-712 713-720 ... 2496 next >
fuel tank removalsnow chainssuspensionlightwheel alignmentremote start
Popular search:
FRONT DOORcenter consolePas pumprefilling coolant systemlamp bulbtransmission fluid reservoirfuel cap