1998 JAGUAR X308 Workshop Manual

ground clearancelanguagewiring diagrammaintenance resetdead batterywiper blades
Popular search:
wheel boltswasher nozzleAntifreezeseatsOBD portradiator capair filter
Previous
Next
Load previous 8 pages

Page 329 of 2490

JAGUAR X308 1998 2.G Workshop Manual 1 0. Measure hub face run-out. Position the gauge so that the pointer contacts the hub face.  Slowly rotate the hub one revolution, the hub run-out must not exceed the specification. Refer

Page 330 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14 . CA UTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work, with clean water. CA UTION: Note the condition of

Page 331 of 2490

JAGUAR X308 1998 2.G Workshop Manual R ear Brake Disc Runout Check Vehicles Without: Brembo Brakes Special Service tools D ial Test Indicator Gauge and Stand. 1 . Raise rear of vehicle and support on stands. Refer to section <<100-02>

Page 332 of 2490

JAGUAR X308 1998 2.G Workshop Manual Me asurement of the brake disc run-out, must be carried-out with the disc and hub parking-brake adjuster-holes aligned. Make sure that wheel bearing end-float is correct. Refer to specification secti

Page 333 of 2490

JAGUAR X308 1998 2.G Workshop Manual   Position the gauge so that the pointer contacts the hub face.  Slowly rotate the hub one revolution, the hub run-out must not exceed the specification. Refer to Specification Section <

Page 334 of 2490

JAGUAR X308 1998 2.G Workshop Manual Rear Brake Disc Runout Check Vehicles With: Brembo Brakes Special Service tools Di al Test Indicator Gauge and Stand. 1. WA RNING: BRAKE DUST, IF INHALED CAN DAMAGE YOUR HEALTH. ALWAYS REMOVE BR

Page 335 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3 . Remove brake pads from caliper. 1. Withdraw pins from caliper. 2. Remove anti-rattle spring. 3. Remove brake pads. 4 . C AUTION: Only remove the bolts securing the caliper anchor bracket to the

Page 336 of 2490

JAGUAR X308 1998 2.G Workshop Manual 5. Make sure that wheel bearing end-float is within specification. Refer to specification section <<204-02>>. 6. NOTE: Measurement of the brake disc run-out, must be carried-out with the disc and
Load next 8 pages
Page:   < prev 1-10 ... 297-304 305-312 313-320 321-328 329-336 337-344 345-352 353-360 361-368 ... 2496 next >
airbag offset clockfuse box locationdashboardheadlightsbrake rotor
Popular search:
pulleyresetrear axlewidthsensorair filterend float