1998 JAGUAR X308 Workshop Manual

trunkcruise controlrear view mirroralarmwheel sizeTPMS reset
Popular search:
dimensionsfuel sensorwiring diagramradio antennaresetcabin filterseats
Previous
Next
Load previous 8 pages

Page 241 of 2490

JAGUAR X308 1998 2.G Workshop Manual 24 . Remove nut and washer from pivot pin. 25 . Remove hub and carrier from wishbone and axle shaft. With draw pivot pin and remove hub and carrier assembly. 26 . CAUTION: Note

Page 242 of 2490

JAGUAR X308 1998 2.G Workshop Manual 28. Using a h ydraulic press, remove hub from carrier. Pla ce large section of special tool (204-113) on press bed, with recess in t ool uppermost. Positi on hub carrier on tool , en

Page 243 of 2490

JAGUAR X308 1998 2.G Workshop Manual I nstallation 33 . Using approved cleaning agents: Wash an d thoroughly dry inner and outer bearings. Thorough ly clean hub carrier payi ng particular attention to bearing cups. 

Page 244 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Install bearing shim. 3. Install inner bearing. 4. Install and fully seat new inner bearing seal using special tool 205-234. 5. Place block of wood on hydrau lic press-bed and position hub

Page 245 of 2490

JAGUAR X308 1998 2.G Workshop Manual 10 . Install washer and nut on pivot pin, but DO NOT tighten nut. 11 . Install hub on axle shaft . Route parking brake cable throu gh hub carrier aperture and install grommet. App

Page 246 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. Inst all wheel speed sensor on hub carrier. Posit i on sensor on hub carrier and install and tighten bolt to 7-10Nm. Conne ct wheel speed sensor harness to sensor. 15 . Usin

Page 247 of 2490

JAGUAR X308 1998 2.G Workshop Manual 20 . Remove nuts and withdraw special tool (204-195) from hub. 21. Install rear wheel. Refer to Section 204-04. 22. Remove stands and lower vehi cle onto wheels. Refer to section 100-02. 23.

Page 248 of 2490

JAGUAR X308 1998 2.G Workshop Manual Rear Su spension - Wh eel Knuckle Bushing Remo val and Installation Remov a l S p ecial Tool(s) Hub Holdin g Tool 2 04-195 (JD227) Hub Pu ller 204-011 (JD 1D) D rive r Handle 100-
Load next 8 pages
Page:   < prev 1-10 ... 209-216 217-224 225-232 233-240 241-248 249-256 257-264 265-272 273-280 ... 2496 next >
trunkbolt patternmaintenancedeactivate airbagESP inoperativecheck engine
Popular search:
Engine generalcooling systemparking brakemaintenance scheduleremove seatscrankshaft pulleyhoses