1998 JAGUAR X308 Workshop Manual

air conditioningTPMSremote controlbrakefuse chartcheck oil
Popular search:
flex plateinterior lightshead lampheaterREAR SHOCKSpurge valvetrunk release
Previous
Next
Load previous 8 pages

Page 2441 of 2490

JAGUAR X308 1998 2.G Workshop Manual 14. Remove undertray from vehicle. 15. Position camber tie down special tool 204-114 on suspension. Fully slacken tool adjuster nut. Position tool in center of ro ad spring and pass uppe

Page 2442 of 2490

JAGUAR X308 1998 2.G Workshop Manual 21. Remove crossbeam to engi ne Hydramount bolts. Remove bolt securing crossbeam to Hydramount. Fully withdraw bolt into crossbeam insert. Repeat procedure to remove and withdraw bolt

Page 2443 of 2490

JAGUAR X308 1998 2.G Workshop Manual 26. Support weight of crossbeam. Position a jack under crossbeam. Place a piece of wood between jack and crossbeam. Raise jack to just support crossbeam. 27. From engine compartm

Page 2444 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 30. CAUTION: Slowly lower the crossbeam just sufficient to provide the required clearance. Lowering the crossbeam excessively can damage the suspension and steering pipes. Careful

Page 2445 of 2490

JAGUAR X308 1998 2.G Workshop Manual correctly seated in body locations. 3. Ensure that both engine hydram ounts are correctly seated in crossbeam locations. 4. From engine compartment, install but do not tighten crossbeam

Page 2446 of 2490

JAGUAR X308 1998 2.G Workshop Manual 7. From engine compartment, tighten crossbeam front RH bolts to 22-28Nm. 8. Install lower steering column on pinion shaft. Move column downwards to engage coupling splines on pinion shaft.

Page 2447 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Remove special tool 303-021 from fender channel. 11. Install crossbeam to engine Hydramount bolts. Install bolt securing Hydramou nt to crossbeam and tighten to 34-46Nm. Repeat proced

Page 2448 of 2490

JAGUAR X308 1998 2.G Workshop Manual 15. Using screws or new scrivets , secure undertray to front bumper cover. 16. Using new tiestrap, secure undertray to crossbeam brace. 17. Using new scrivets, secure un dertray to each wh
Load next 8 pages
Page:   < prev 1-10 ... 2409-2416 2417-2424 2425-2432 2433-2440 2441-2448 2449-2456 2457-2464 2465-2472 2473-2480 ... 2496 next >
four wheel drivenavigation systemwiper sizeadbluehigh beambattery location
Popular search:
303-06trunkfuse diagramoil pressurewipersstart stop buttonvapour