1998 JAGUAR X308 Workshop Manual

oil pressuredeactivate airbaglumbar supportwheel torquewheel bolt torqueheadlamp
Popular search:
radio antennaPas pumprear seatinstrument clusterjacking pointswater pumpcheck engine light
Previous
Next
Load previous 8 pages

Page 705 of 2490

JAGUAR X308 1998 2.G Workshop Manual (or other sui table type). Insert the drain / bleed tube into the fuel container. Follow the manufa cturers instructions and depressurise the fuel system. 5. Store the drained fuel safely and

Page 706 of 2490

JAGUAR X308 1998 2.G Workshop Manual 11. Disconnect the air cleaner cover. 1. Remove the five clips wh ich secure the air cleaner cover. 12. Remove the intake tube / air flow meter / air cleaner cover assembly. 1. Remove the i

Page 707 of 2490

JAGUAR X308 1998 2.G Workshop Manual 16. Disconnect the coolant hoses from the throttle body. Release the clip which secures the coolant return hose and disconnect the hose. Fit a blanking plug to the hose to prevent water leak

Page 708 of 2490

JAGUAR X308 1998 2.G Workshop Manual 20. Release the induction elbow su pport; working from the right hand side. 1. Disconnect the vacuum pi pe from the centre of the induction elbow. 2. Remove the upper bolt from the induction e

Page 709 of 2490

JAGUAR X308 1998 2.G Workshop Manual 24. Disconnect the fuel return hose. 1. Disconnect the fuel retu rn hose at the Quick Fit connector, using special tool 310 - 054. 25. Remove the inlet manifold. 1. Remove the ten bolts whi

Page 710 of 2490

JAGUAR X308 1998 2.G Workshop Manual 3. Remove and discard the regulator O-ring seal. 28. Remove the fuel feed pipe from the manifold. 1. Remove the two bolts which secure the fuel feed pipe to the inlet manifold. 2. Remove the

Page 711 of 2490

JAGUAR X308 1998 2.G Workshop Manual Installation 32. Remove and discard the sixt een sealing rings from the injectors. 33. Remove the throttle induction elbow from the inlet manifold. 1. Remove the seven bolts which secure t

Page 712 of 2490

JAGUAR X308 1998 2.G Workshop Manual 2. Fit the feed pipe to the manifold. 3. Fit the two bolts which secure the feed pipe. 4. Fit the fuel cross over elbow to the inlet manifold. 1. Lubricate and fit new O-ri ng seals to the cros
Load next 8 pages
Page:   < prev 1-10 ... 673-680 681-688 689-696 697-704 705-712 713-720 721-728 729-736 737-744 ... 2496 next >
glove boxchange timebulbchargingbatterytailgate
Popular search:
Heel boardcoolant reservoirbrake light switchparking sensorsphoneengine coolantSOLENOID